HP BMD00022 manual Vlan configuration, Command /cfg/l2/vlan, Def list of port numbers

Table 121 LACP Port Configuration Menu options

Command	Description
adminkey <1-65535>	Set the admin key for this port. Only ports with the same admin key and
	oper key (operational state generated internally) can form a LACP trunk
	group.
cur	Displays the current LACP configuration for this port.

VLAN configuration

Command: /cfg/l2/vlan <1-4094>

[VLAN 1 Menu]
name	- Set VLAN name
stg	- Assign VLAN to a Spanning Tree Group
add	- Add port to VLAN
rem	- Remove port from VLAN
def	- Define VLAN as list of ports
ena	- Enable VLAN
dis	- Disable VLAN
del	- Delete VLAN
cur	- Display current VLAN configuration

The commands in this menu configure VLAN attributes, change the status of the VLAN, delete the VLAN, and change the port membership of the VLAN.

By default, the VLAN menu option is disabled except VLAN 1, which is always enabled. The HP 10GbE switch supports a maximum of 1,000 VLANs. VLAN 4095 is reserved for switch management.

NOTE: See the HP 10Gb Ethernet BL-c Switch Application Guide for information on VLANs.

The following table describes the VLAN Configuration Menu options.

Table 122 VLAN Configuration Menu options

Command	Description
name <1-32 characters>	Assigns a name to the VLAN or changes the existing name. The default
	VLAN name is the first one.
stg <1-127>	Assigns a VLAN to a spanning tree group. If MSTP is used, the range
	is 0-32 (0 = CIST).
add <port number>	Adds ports to the VLAN membership.
rem <port number>	Removes ports from the VLAN membership.
def <list of port numbers>	Defines which ports are members of this VLAN. Every port must be a
	member of at least one VLAN. By default, it defines ports to VLAN 1.
ena	Enables this VLAN.
dis	Disables this VLAN without removing it from the configuration.

Configuration Menu 152