HP BMD00022 manual NTP server configuration, Command /cfg/sys/ntp, Mgtdata

IMPORTANT: If TACACS+ is enabled, you must login using TACACS+ authentication when connecting via the console or Telnet/SSH/HTTP/HTTPS. Backdoor for console is always enabled, so you can connect using notacacs and the administrator password even if the backdoor (bckdoor) or secure backdoor (secbd) are disabled.

If Telnet backdoor is enabled (bckdoor ena), type notacacs as a backdoor to bypass TACACS+ checking, and use the administrator password to log into the switch. The switch allows this even if TACACS+ servers are available.

If secure backdoor is enabled (secbd ena), type in notacacs as a backdoor to bypass TACACS+ checking, and use the administrator password to log into the switch. The switch allows this only if TACACS+ servers are not available.

NTP server configuration

Command: /cfg/sys/ntp

[NTP Server Menu]

prisrv	- Set primary NTP server address
secsrv	- Set secondary NTP server address
intrval	- Set NTP server resync interval
on	- Turn NTP service ON
off	- Turn NTP service OFF
cur	- Display current NTP configuration

This menu enables you to synchronize the switch clock to a Network Time Protocol (NTP) server. By default, this option is disabled.

The following table describes the NTP Server Configuration Menu options.

Table 84 NTP Server Configuration Menu options

Command	Description
prisrv <IP address>	Configures the IP addresses of the primary NTP server to which you want to
mgtdata	synchronize the switch clock.
	By default, the mgt option for the management port is used. To use data
	ports, specify the data option.
secsrv <IP address>	Configures the IP addresses of the secondary NTP server to which you want to
mgtdata	synchronize the switch clock.
intrval <1-44640>	Specifies the interval, that is, how often, in minutes (1-44640), to
	resynchronize the switch clock with the NTP server. The default is 1440
	seconds.
on	Enables the NTP synchronization service.
off	Disables the NTP synchronization service. This is the default.
cur	Displays the current NTP service settings.

Configuration Menu 118