HP BMD00022 manual Network Filter configuration, Route Map configuration, Command /cfg/l3/nwf

Network Filter configuration

Command: /cfg/l3/nwf <1-256>

[IP Network Filter		1 Menu]
addr	- IP	Address
mask	- IP	Subnet mask
enable	- Enable Network Filter
disable	- Disable Network Filter
delete	- Delete Network Filter
current	- Display current Network Filter configuration

The following table describes the Network Filter Configuration Menu options.

Table 136 Network Filter Configuration Menu options

Command

addr <IP address>

mask <IP subnet mask>

Description

Sets the starting IP address for this filter. The default address is 0.0.0.0.

Sets the IP subnet mask that is used with /cfg/l3/nwf/addr to define the range of IP addresses that will be accepted by the peer when the filter is enabled. The default value is 0.0.0.0.

enable	Enables the Network Filter configuration.
	Disables the Network Filter configuration.
disable
	Deletes the Network Filter configuration.
delete
	Displays the current the Network Filter configuration.
current

Route Map configuration

Command: /cfg/l3/rmap <1-32>

[IP Route Map 1 Menu]

alist	- Access List number
metric	- Set metric of the matched route
type	- Set OSPF metric-type of the matched route
prec	- Set the precedence of this route map
enable	- Enable route map
disable	- Disable route map
delete	- Delete route map
current	- Display current route map configuration

Routing maps control and modify routing information. The map number <1-32>represents the routing map you wish to configure.

The following table describes the Route Map Configuration Menu options.

Table 137 Route Map Configuration Menu options

Command	Description
alist <1-8>	Displays the Access List menu.
metric <0-16777214>none	Sets the metric of the matched route.

Configuration Menu 163