
Configuring SNMP SmartAgents on Devices
(NMS). This allows the NMS to access these devices directly over the ATM network instead of going across routers.
3Configure the IP address, and default gateway of Bridge 0 in each of the edge device units. See the device Installation and Setup Guide for the devices you are using.
Configuring SNMP Community names set on the NMS must correspond with community SmartAgents and names set on the agent(s). Configure the SNMP generic parameters on
Parameters the ATM and VLAN Network Manager as follows:
1Configure the default SNMP Community Setting on the Network Management Platform according to Table
Table 2-1 Configuring SNMP Community Settings
Device | SNMP Community |
Setting | |
|
|
CoreBuilder 7000 | Private |
CoreBuilder 7X00 |
|
SuperStack II Switch 2700 |
|
SuperStack II Switch | Security |
1000/3000/Desktop Switch |
|
SuperStack II Switch 2000 | Private |
CoreBuilder 2500/6000 | Public |
CoreBuilder 5000 Switch |
|
Module |
|
SuperStack II Switch 2000 | Security |
TR |
|
NetBuilder II | Public |
CoreBuilder 4000 | Public |
|
|
If default SNMP Communities are changed in the devices, you must enter the new communities as well.
2Verify the IP/SNMP connectivity using the IP Map.
All devices in the management subnet should appear on the IP Map of the management platform. The IP connectivity is verified by the appearance of the IP address. The SNMP connectivity is verified by the appearance of the device icon. The process of establishing connectivity should take about 5 minutes.