3Com 4.2.2 manual System Messages B-5

System Messages B-5

Table B-1System Messages

Message Type Meaning Action

VLAN Move: SNMP SET error - [SNMP error status]- in device -[device IP address].

Device skipped.

Wait for the ATMVLAN maps to refresh. Check the VLAN maps for results of the previous operation and then retry.

VLAN Move: No available LECs left in error device - [device IP address]. Device skipped.

Remove one or more VLANs from the device. To remove, use the VLAN Move operation and move all the device segments from the VLAN.

VLAN Move: Cannot find LEC in	error
device [device IP address]. Device
skipped.

Reset CoreBuilder 2500/6000 or LANplex 2016/5000 and retry the operation. If you do not succeed, you may have a problem with your device.

VLAN Move: Cannot create LEC - No	error		Check the ATM card.
ATM card in device [device IP address].
Device skipped.
VLAN Move: Cannot move to VLAN -	error	This move operation is	You may perform one of the
[VLANID] in device - [device IP		intended to the create a new	following actions:
address]. Might create two VLANs that		VLAN. Because of a mismatch	1 Define the “admin” and
use the same ELAN. Device skipped.		between the current and	the “default” VLANs in the
		config VLANs in the device,
			VirtualLANs Configuration
		creating the desired VLAN
			window.
		might result in two VLANs
			2 Reset device to synchronize
		that use the same ELAN.
			the current and config
			VLANs.
			3 Using the LMA, remove
			non-existing VLANs from
			the device.
			4 Verify that the desired
			VLAN is using its primary
			ELAN.
Polling: SNMP GET Error - [SNMP	error		Restart polling.
status] - in device - [device IP
Address]. Polling aborted.
Polling: SNMP GET timeout in device	info		None
[device IP address]. Retrying.
VC Path Assistant: VC list is full in	error	No space to define new PVC.	Delete some VCs and try
device - [device IP address]. Operation			again
aborted.