3Com 4.2.2 manual 2ATMvLAN Customization Files, Filename Description

Starting Up the ATM and VLAN Manager 2-13

These files and directories must be backed-up before installing/upgrading to a newer release of the ATM and VLAN Management application.

The ATMvLAN NMSetup Wizard allows you to modify these configuration files. This customization will take effect upon restarting the application after the customization is performed using the customization Wizard.

Table 2-2 lists the names of the some files that you can customize using the NMSetup Wizard.

Table 2-2ATMvLAN Customization Files

Filename	Description
mediationd.cnf	This file has the information about all the distributed pollers
	and the devices that each poller is responsible. The setup of
	distributed pollers is explained in the See “Setting Up for
	Distributed Polling” on page 2-4.
	This file is customized by the Setup Wizard.
noplatdis.cnf	If this file exists, the application will not discover from the
	platform database. It will rely on manual population of the
	device database
	(C:\TranscendNT\ATMvLAN\runtime\sav\127.0.0.1.ppp)
127.0.0.1.ppp	using the Manual Discovery Tool. The default is to use
	platform discovery and this file by default is
	noplatdis.cnf.bak
	This file is customized by the Setup Wizard
numcpsrvs.cnf	The number set in this file (1-16) determines the number of
	LESs displayed in the maps. So if you are only using 2
	LES/CoreBuilder, set the number to 2 and only the first 2
	LESs of the CoreBuilder are shown in the maps.
	This file is not customized by the Setup Wizard.
protimeout.cnf	The number in this file determines the number of seconds
	that the application will wait for the network to settle down
	before it start the LES failure verification process. This
	number could be tuned down to about 120 seconds if
	there are not redundant switch engines in the network. See
	Chapter 4 for a more detailed description. If there are
	redundant switch engines, the default number should be
	used.
	This file is customized by the Setup Wizard.
VnRgb.dat	Is the file where the VLAN aliases and color information is
	saved after the aliases and colors are set. This file must be
	saved when the application is upgraded to a newer release.
	This files is customized by using the VLAN Aliases and
	Colors setup assistant.