HP BMD00022 manual RIP Interface configuration, Command /cfg/l3/rip/if

Configures the route metric, which indicates the relative distance to the destination. The default value is 1.

Configures the authentication type. The default is none.

Configuration Menu

Description

Configures the RIP version used by this interface. The default value is version 2.

When enabled, the switch supplies routes to other routers. This command is enabled by default.

When enabled, the switch learns routes from other routers. This command is enabled by default.

When enabled, the switch uses split horizon with poisoned reverse. When disabled, the switch uses only split horizon. The default value is disabled.

Enables or disables split horizon. The default value is enabled.

Enables or disables Triggered Updates. Triggered Updates are used to speed convergence. When enabled, Triggered Updates force a router to send update messages immediately, even if it is not yet time for the update message. The default value is enabled.

Enables or disables multicast updates of the routing table (using address 224.0.0.9). The default value is enabled.

When enabled, the switch accepts RIP default routes from other routers, but gives them lower priority than configured default gateways. When disabled, the switch rejects RIP default routes. The default value is

disabled.

RIP Interface Configuration Menu options

RIP Interface configuration

Command: /cfg/l3/rip/if <1-249>

[RIP Interface 1 Menu]

version	- Set RIP version
supply	- Enable/disable supplying route updates
listen	- Enable/disable listening to route updates
poison	- Enable/disable poisoned reverse
split	- Enable/disable split horizon
trigg	- Enable/disable triggered updates
mcast	- Enable/disable multicast updates
default	- Set default route action
metric	- Set metric
auth	- Set authentication type
key	- Set authentication key
enable	- Enable interface
disable	- Disable interface
current	- Display current RIP interface configuration

The RIP Menu is used for configuring Routing Information Protocol parameters. This option is turned off by default.

NOTE: Do not configure RIP version 1 parameters if your routing equipment uses RIP version 2.

The following table describes the RIP Interface Configuration Menu options.

Table 140

Command

version 12both

supply disableenable

listen disableenable

poison disableenable

split disableenable

trigg disableenable

mcast disableenable

default nonelistensupplyboth

metric <1-15>

auth nonepassword

166