HP BMD00022 manual Protocol Vlan configuration, Command /cfg/l2/vlan x/pvlan, Pty Ether2SNAPLLC

Table 122	VLAN Configuration Menu options
Command	Description
del	Deletes this VLAN.
cur	Displays the current VLAN configuration.

IMPORTANT: All ports must belong to at least one VLAN. Any port which is removed from a VLAN and which is not a member of any other VLAN is automatically added to default VLAN #1. You cannot remove a port from VLAN #1 if the port has no membership in any other VLAN. Also, you cannot add a port to more than one VLAN unless the port has VLAN tagging turned on. See the tag command, in the “Port configuration” section earlier in this chapter.

Protocol VLAN configuration

Command: /cfg/l2/vlan x/pvlan x

[VLAN 1 Protocol 1 Menu]

pty	- Set protocol type
protocol	- Select a predefined protocol
prio	- Set priority to protocol
add	- Add port to PVLAN
rem	- Remove port from PVLAN
ports	- Add/Remove a list of ports to/from PVLAN
tagpvl	- Enable/Disable port tagging for PVLAN
taglist	- Enable tagging a port list for PVLAN
ena	- Enable protocol
dis	- Disable protocol
del	- Delete protocol
cur	- Display current PVLAN configuration

The following table describes the Protocol VLAN Configuration Menu options.

Table 123 Protocol VLAN Configuration Menu options

Command	Description
pty <(Ether2SNAPLLC)>	Configures the frame type and the Ethernet type for the selected protocol.
<Ethernet type>	Ethernet type consists of a 4-digit (16 bit) hex code, such as 0080 (IPv4).
protocol	Selects a pre-defined protocol, as follows:
	•	decEther2
	•	ipv4Ether2
	•	ipv6Ether2
	•	ipx802.2
	•	ipx802.3
	•	ipxEther2
	•	ipxSnap
	•	netbios
	•	rarpEther2
	•	sna802.2
	•	snaEther2
	•	vinesEther2
	•	xnsEther2

Configuration Menu 153