HP BMD00022 manual Spanning Tree configuration, Command /cfg/l2/stp, Edge disableenable

Table 111 CIST Port Configuration Menu options

Command	Description
edge disableenable	Enables or disables this port as an edge port. An edge port is not
	connected to a bridge, and can begin forwarding traffic as soon as the link
	is up. Configure server ports as edge ports (enabled). This command is
	disabled by default.
on	Enables CIST on the port.
off	Disables CIST on the port.
cur	Displays the current CIST port configuration.

Spanning Tree configuration

Command: /cfg/l2/stp <1-128>

[Spanning Tree Group 1 Menu]

brg	- Bridge parameter menu
port	- Port parameter menu
add	- Add VLAN(s) to Spanning Tree Group
remove	- Remove VLAN(s) from Spanning Tree Group
clear	- Remove all VLANs from Spanning Tree Group
on	- Globally turn Spanning Tree ON
off	- Globally turn Spanning Tree OFF
default	- Default Spanning Tree and Member parameters
cur	- Display current bridge parameters

The HP 10GbE switch supports the IEEE 802.1D Spanning Tree Protocol (STP) and Cisco proprietary PVST and PVST+ protocols. You can configure up to 127 spanning tree groups on the switch (STG 128 is reserved for switch management). Spanning Tree is turned on by default.

NOTE: When RSTP is turned on, only STP group 1 can be configured.

The following table describes the Spanning Tree Configuration Menu options.

Table 112 Spanning Tree Configuration Menu options

Command	Description
brg	Displays the Bridge Spanning Tree Menu.
port <port number>	Displays the Spanning Tree Port Menu.
add <1-4094>	Associates a VLAN with a spanning tree and requires an external VLAN ID as a
	parameter.
remove <1-4094>	Breaks the association between a VLAN and a spanning tree and requires an
	external VLAN ID as a parameter.
clear	Removes all VLANs from a spanning tree.
on	Globally enables Spanning Tree Protocol.
off	Globally disables Spanning Tree Protocol.
default	Restores a spanning tree instance to its default configuration.
	Configuration Menu 144