HP BMD00022 manual SNMPv3 configuration, Command /cfg/sys/ssnmp/snmpv3, Wcomm 1-32 characters

Table 85 System SNMP Configuration Menu options

Command	Description
wcomm <1-32 characters>	Configures the SNMP write community string. The write community string
	controls SNMP “set” and “get” access to the switch. It can have a
	maximum of 32 characters. The default write community string is private.
timeout <1-30>	Sets the timeout value for the SNMP state machine. The range is 1-30
	minutes. The default value is 5 minutes.
auth disableenable	Enables or disables the use of the system authentication trap facility. The
	default setting is disabled.
linkt <port>	Enables or disables the sending of SNMP link up and link down traps. The
[disableenable]	default setting is enabled.
ufd	Enables or disables the sending of Uplink Failure Detection traps. The
	default setting is disabled.
cur	Displays the current SNMP configuration.

SNMPv3 configuration

Command: /cfg/sys/ssnmp/snmpv3

[SNMPv3 Menu]
usm	- usmUser Table Menu
view	- vacmViewTreeFamily Table Menu
access	- vacmAccess Table Menu
group	- vacmSecurityToGroup Table Menu
comm	- community Table Menu
taddr	- targetAddr Table Menu
tparam	- targetParams Table Menu
notify	- notify Table Menu
v1v2	- Enable/disable V1/V2 access
cur	- Display current SNMPv3 configuration

SNMP version 3 (SNMPv3) is an extensible SNMP Framework that supplements the SNMPv2 Framework by supporting the following:

•a new SNMP message format

•security for messages

•access control

•remote configuration of SNMP parameters

For more details on the SNMPv3 architecture please see RFC2271 to RFC2275.

Configuration Menu 120