HP BMD00022 manual Management Networks configuration, Command /cfg/sys/access/mgmt

Table 95 System Access Configuration Menu options

Command	Description
wport <TCP port number>	Sets the switch port used for serving switch Web content. The default is
	HTTP port 80.
snmp disableread-	Disables or provides read-only/write-read SNMP access.
onlyread-write
tsbbi enabledisable	Enables or disables BBI configuration control s for Telnet and SSH.
tnet disableenable	Enables or disables Telnet access. You see this command only if you are
	connected to the switch through a serial connection. The default setting is
	enabled.
tnport <TCP port number>	Sets an optional telnet server port number for cases where the server listens
	for telnet sessions on a non-standard port.
tport <TFTP port number>	Sets an optional telnet server port number for cases where the server listens
	for TFTP sessions on a non-standard port.
cur	Displays the current system access parameters.

Management Networks configuration

Command: /cfg/sys/access/mgmt

[Management Networks Menu]

add	- Add mgmt network definition
rem	- Remove mgmt network definition
cur	-	Display current mgmt network definitions
clear	-	Clear current mgmt network definitions

The following table describes the Management Networks Configuration menu options. You can configure up to 10 management networks on the switch.

Table 96 Management Network Configuration menu options

Command	Description
add <IP address> <IP mask>	Adds a defined network through which switch access is allowed through
	Telnet, SNMP, RIP, or the browser-based interface. A range of IP
	addresses is produced when used with a network mask address. Specify
	an IP address and mask address in dotted-decimal notation.
rem <IP address> <IP mask>	Removes a defined network, which consists of a management network
	address and a management network mask address.
cur	Displays the current management networks parameters.
clear	Clears the management network definitions.

Configuration Menu 128