HP BMD00022 IP interface configuration, Command /cfg/l3/if, Addr IP address, Mask IP subnet mask

IP interface configuration

Command: /cfg/l3/if <1-250>

[IP Interface	1	Menu]
addr	- Set IP address
mask	- Set subnet mask
vlan	- Set VLAN number
relay	- Enable/disable BOOTP relay
ena	- Enable IP interface
dis	- Disable IP interface
del	- Delete IP interface
cur	- Display current interface configuration

The switch can be configured with up to 250 IP interfaces. Each IP interface represents the switch on an IP subnet on your network. The IP Interface option is disabled by default.

The following table describes the IP Interface Configuration Menu options.

Table 130 IP Interface Configuration Menu options

Command	Description
addr <IP address>	Configures the IP address of the switch interface, using dotted decimal
	notation. For example, 192.2.14.101
mask <IP subnet mask>	Configures the IP subnet address mask for the interface using dotted
	decimal notation. For example, 255.255.255.0
vlan <1-4094>	Configures the VLAN number for this interface. Each interface can belong
	to one VLAN, though any VLAN can have multiple IP interfaces in it.
relay disableenable	Enables or disables the BOOTP relay on this interface. The default value is
	enabled.
ena	Enables this IP interface.
dis	Disables this IP interface.
del	Removes this IP interface.
cur	Displays the current interface settings.

NOTE: If you enter an IP address for interface 1, you are prompted to change the BOOTP setting.

Configuration Menu 159