HP BMD00022 manual Default Gateway configuration, Command /cfg/l3/gw 1-4, Arp disableenable

Default Gateway configuration

Command: /cfg/l3/gw <1-4, 254>

[Default gateway 1 Menu]

addr	- Set IP address
intr	- Set interval between ping attempts
retry	- Set number of failed attempts to declare gateway DOWN
arp	- Enable/disable ARP only	health checks
ena	- Enable default gateway
dis	- Disable default gateway
del	- Delete default gateway
cur	- Display current default	gateway configuration

The switch supports up to four gateways, plus the management gateway 254. By default,

no gateways are configured on the switch. Enter 1, 2, 3, or 4, or 254 in the command as the <gateway number>, depending upon which gateway you want to configure.

The following table describes the Default IP Gateway Configuration Menu options.

Table 131 Default IP Gateway Configuration Menu options

Command	Description
addr <IP address>	Configures the IP address of the default IP gateway using dotted decimal notation.
	For example, 192.4.17.44.
intr <0-60>	The switch pings the default gateway to verify that it is up. The intr option sets
	the time between health checks. The range is from 0 to 60 seconds. The default is
	2 seconds.
retry <1-120>	Sets the number of failed health check attempts required before declaring this
	default gateway inoperative. The range is from 1 to 120 attempts. The default is 8
	attempts.
arp disableenable	Enables or disables Address Resolution Protocol (ARP) health checks. This
	command is disabled by default.
ena	Enables the gateway for use.
dis	Disables the gateway.
del	Deletes the gateway from the configuration.
cur	Displays the current gateway settings.

Configuration Menu 160