MULTITASKER
Command Format: {CLFGk}
Gk = Group number (k = # from
See the {CLFC} command for details.
34.{STA}
This command is used to show the
The {STA} command must be programmed into a subroutine for the front panel.
NOTE: This command is used in conjunction with the {CLF} command.
Command Format: {WRSy=LED*=0,STA}
Sy = subroutine (n is a # from 1 to 180)
Example:
C4 is an 8X8 matrix card and the following is programmed into the front panel:
∙Keys
∙Keys
∙Sub 2 contains the following: {WRS2=LED*=0,STA}.
∙Key 2 is programmed as follows: {WRK2=2,0,0,0,0}.
Connect Input 1 to Outputs 1 and 2 on C4 and verify the connection. Use the following steps:
1.From the front panel, connect Input 1 (Key 13) to Output 1 (Key 29). LEDs 13 and 29 flash.
2.Next, connect Input 1 (Key 13) to Output 2 (Key 30). LEDs 13 and 30 flash.
3.Press any key and the LEDs stop flashing.
4.Press Key 2 and then Key 13. LEDs 13, 29, and 30 flash indicating Input 1 is connected to Outputs 1 and 2.
NOTE: An input or output key can be selected to see its connections. In either case, all connections would be indicated. Selecting an input key will show all the outputs to which the input is connected. An output key will show only the one input to which it is connected.
KEY COMMANDS
Key commands define which subroutines will be performed when a key is pressed under various conditions and how it will respond to activation. Keys may also be given labels to help identify their usage.
35.{RDK}
This command displays the contents of one or more key programs. The subroutines defined will be displayed first, then the key label, if any. Next, if the key is defined as volume control, the word VOLUME will be displayed. Lastly, if the key is locked, the word LOCKED will be displayed.
Command Format: {RDKn}
Kn = key program (n = # of key program)
{RDKn}: Display a single key program.
{RDK*}: | Display all key programs. |
Example 1:
Display the program definition for Key 1 by sending {RDK1} and the system will display the program in the following format:
KEY1 : 2,5,10,20,30 LABEL VOLUME LOCKED
KEY1 | The key number requested. |
2 | Go to SUB2 for key state 1. |
5 | Go to SUB5 for key state 2. |
10 | Go to SUB10 for key state 3. |
20 | Go to SUB20 for key state 4. |
30 | Go to SUB30 for key state 5. |
LABEL | The key label text will be displayed if |
| a label was defined using {WRLK}. |
VOLUME | VOLUME will be displayed if the key |
| was set using {SETVK}. |
LOCKED | LOCKED will be displayed if the key |
| was locked using {LOCK}. |
17 |