Altinex MT101-115, MT101-117, MT101-114 Application Diagrams, Diagram 1 Installation Instructions

MULTITASKER

APPLICATION DIAGRAMS 5

DIAGRAM 1 – INSTALLATION INSTRUCTIONS

WARNING

Disconnect the AC power cord from the enclosure before making any changes.

LARGE 8-PIN HEADER	SMALL 10-PIN HEADER
on PCB-A and PCB-B	on PCB-A and PCB-B

	Connect the signal cable
Connect power from the power
	connector from front panel
supply connector as shown.
	PC board as shown.

Connect the AC power cable from the rear panel of the enclosure to the power supply.

Connect the ribbon cable from the rear DB9 connector on the rear of the enclosure to the front panel PC board.

PCB-B

POWER SUPPLY

PCB-A

TO PCB-A

POWER

TO PCB-A

SIGNAL

FRONT PANEL PC BOARD

Make sure the ribbon cable is on this side as shown.

10-PIN

HEADER P4

Connect the signal cable to PCB-B.

Connect the 10-pin connector of the power supply "Y" cable to the power supply. Next, connect the two 8-pin connectors to enclosure headers PCB-A and PCB-B as shown.

Connect the signal cable to PCB-A.

Make sure the ribbon cables are on this side of the connector as shown.

NOTE
On some versions, P3 is	10-PIN	10-PIN
slightly under the power	HEADER
supply card. The cable	P3	HEADER
can be installed without		P1
removing the power
supply.	TO PCB-B	TO PCB-A

400-0402-003 5