Advantek Networks AWN-MIMO-54RA user manual FCC Warning

Page 2

FCC Warning

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communication. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to which

-Consult the dealer or an experienced radio/TV technician for help. the receiver is connected.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of about eight inches (20cm) between the radiator and your body.

This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.

CE Mark Warning

This is a Class B product. In a domestic environment, this product may cause radio interference, in which case the user may be required to take adequate measures.

Copyright

2006 All Rights Reserved. No part of this document can be copied or reproduced in any form without written consent from the company.

1

Image 2
Contents 802.11g, 54Mbps Mimo PCI Wireless Adapter User’s Manual FCC Warning Revision History Contents Wireless LAN has Activity ACT data being sent Light Status DescriptionHardware Diagram Installation Procedure Adjust the antenna position Place the PC as high as possibleInstall the Driver & Utility Page Page Page Page For Windows Vista x86 & x64 bit Page Choose Properties Æ click Device Manager To setup Wireless Network in Windows Vista Operation System Choose Connect to a network Page Wireless Network Configuration Utility Configuration utilityProfile 2Link Status 3Site Survey Configure the Profile Network Type Authentication and Security Page 3 802.1x Setting-Certification Encryption ModeAn example for MD5 Authentication 4 802.1x Setting-CA Server Tunneled Authentication4Statistics Wireless Mode AdvancedPage Click WMM Enable Click Apply QoSPage Enable WMM Power Save Click WMM Power Save Enable. And Click Setting… buttonEnable DLS Direct Link Setup Click Direct Link Setup Enable. And Click Apply buttonSetting of DLS indicates as follow Link Setup Describe DLS Status as followPage 7About Troubleshooting What is the Ieee 802.11g standard? What does Ieee 802.11 feature support?