Advantek Networks AWN-MIMO-54RA user manual Advanced, Wireless Mode

Page 32

3.5 Advanced

In the “Advanced”, you can configure more advanced settings, for example: wireless Mode, B/G Protection, Tx Rate, Country Region Code…etc.

Wireless Mode:

802.11B/G mix – If you have a mix of 802.11b & 802.11g wireless stations in your network, it is recommended to setting the card to this mode. This mode is also the default setting.

802.11B only – This adapter can be compatible with both 802.11g and 802.11b wireless stations. If there are only 802.11b wireless stations in the network, you can set the adapter to this mode.

802.11G only –This adapter can be compatible with both 802.11g and 802.11b wireless stations. If there are only 802.11g wireless stations in the network, you can set the adapter to this mode.

Select Your Country Region Code: The available channel differs from different countries.

For example: USA (FCC) is channel 1-11, Europe (ETSI) is channel 1-13. The operating frequency channel will be restricted to the country user located before importing. If you are in different country, you have to adjust the channel setting to comply the regulation of the country.

B/G Protection: If you have a mix of 802.11b & 802.11g wireless stations in the network, it is recommended to enable the protection mechanism. This mechanism can decrease the rate of data collision between 802.11b and 802.11g wireless stations. When the protection mode is enabled, the throughput of the adapter will be a little lower due to many of frame traffic should

31

Page 31 Page 33
Image 32
Page 31 Page 33
Contents 802.11g, 54Mbps Mimo PCI Wireless Adapter User’s Manual FCC Warning Revision History Contents Wireless LAN has Activity ACT data being sent Light Status DescriptionHardware Diagram Installation Procedure Adjust the antenna position Place the PC as high as possibleInstall the Driver & Utility Page Page Page Page For Windows Vista x86 & x64 bit Page Choose Properties Æ click Device Manager To setup Wireless Network in Windows Vista Operation System Choose Connect to a network Page Wireless Network Configuration Utility Configuration utilityProfile 2Link Status 3Site Survey Configure the Profile Network Type Authentication and Security Page 3 802.1x Setting-Certification Encryption ModeAn example for MD5 Authentication 4 802.1x Setting-CA Server Tunneled Authentication4Statistics Wireless Mode AdvancedPage Click WMM Enable Click Apply QoSPage Enable WMM Power Save Click WMM Power Save Enable. And Click Setting… buttonEnable DLS Direct Link Setup Click Direct Link Setup Enable. And Click Apply buttonSetting of DLS indicates as follow Link Setup Describe DLS Status as followPage 7About Troubleshooting What is the Ieee 802.11g standard? What does Ieee 802.11 feature support?
Top Page Image Contents