![](/images/new-backgrounds/1266944/26694463x1.webp)
Dual T1/PRI Commands
Menu Options | Forcing receiver reframe on the span lines |
4 and 6 | Issuing command options 4 or 6 forces the T1 framer to reframe or |
| |
| |
| Use these options if error conditions occur. Observe error conditions |
| through span line 1 and 2 Alarm/Event status screens. |
Menu Options | Disconnecting calls on specific span line |
5 and 7 | Options 5 and 7 allow you to disconnect calls on specific |
| |
| or time slots, on span lines 1 and 2. Enter the number of the channel or |
| channels you wish to disconnect calls on at the command prompt. |
| Valid channels are |
| Attempting to disconnect a call on channel 24 will produce an ERROR |
| message and reject the entire command even if other valid channels were |
| entered. |
| Use the following syntax when configuring this option: |
| BC# (for a single channel) |
| BC#,BC#,BC#,... (for single, |
| |
| Where: |
| BC# = |
Menu Option 8 | Forcing the NAC to master the TDM bus |
| This feature is not supported. |
Menu Options | Entering and exiting locally initiated loopbacks on the span lines |
9 and 10 | Issue loopback tests to verify that the span’s framer circuitry is functioning |
| |
| properly and to test Telco links. Menu options 9 and 10 control loopback |
| tests for span lines 1 and 2. Initiate or terminate loopback tests from |
| these prompts. |
| This command turns the local interface into a “mirror” facing back |
| toward the network. |