ADC Network Unit user manual Front Panel, Overview August 7, Eniu LED Indicators and Controls

Page 12

Chapter 1: Overview

August 7, 2006

FRONT PANEL

Each ENIU has three LEDs, a STATUS LED, a LPBK LED, and a LOS/LINK LED. Under normal operation the ENIU STATUS LED is green. Front panel indicators and controls are defined in Table 1-1 on page 1-2. An ENIU is shown in Figure 1-2.

ENI-EGXXEGXX1B

 

 

 

20476--A1

 

 

Figure 1-2. ENIU Front View

 

Table 1-1. ENIU LED Indicators and Controls

SIGNAL

COLOR

 

STATUS

 

 

 

 

STATUS

GREEN

 

ENIU Power OK and operating properly.

 

 

 

 

 

RED

 

A service affecting fault exists within the ENIU.

 

 

 

 

 

OFF

 

ENIU Power OFF.

 

 

 

 

LPBK

GREEN

 

Flashing if loopback is active on the ENIU.

 

 

 

 

 

OFF

 

No active loopback detected.

 

 

 

 

LOS/ Link

RED

 

LOS detected on the network or subscriber interface.

 

 

 

 

 

OFF

 

Normal operation.

 

 

 

 

CONTROL

DESCRIPTION

 

 

 

 

Reset

Pressing the reset button restarts the ENIU.

 

 

LPBK

Manual switch to enable or disable loopback at the ENIU.

 

 

 

 

1-2

AIWN-UM-7001-01

Image 12
Contents Ethernet Network Interface Unit Eniu Revision History Table of Contents Table of Contents August 7 AIWN-UM-7001-01 List of Figures List of Figures August 7 AIWN-UM-7001-01 List of Tables AIWN-UM-7001-01 ViiList of Tables August 7 Viii AIWN-UM-7001-01 About this Manual IntroductionOrganization Intended AudienceInspecting Your Shipment About This Manual August 7Reader Alert Meaning Overview Product DescriptionEniu LED Indicators and Controls Front PanelOverview August 7 Installation Desktop InstallationSurface Mount Installation Power and Ground Connections Installation August 7Ground Connection Eniu Rear View with RJ-45 Connector Power Connection Four-Pin Power Plug Wiring DiagramEniu Front View with RJ-45 Connector RJ-45 Ethernet Cables Cabling100 Mbps Ethernet RJ-45 Connector Pin # BaseT Ethernet RJ-45 Connector Pin #Function Optical CablesEIA-232 Communication Port Defaults DB-9 Communications CableCOMMAND-LINE Interface CLI Command PromptCLI Command Prompts Effective privilege Commands Overview Commands ListSecurity Initial SET-UPConfiguration GET ConfigurationSET Networksubscriber Interface Speed 101001000 Autoforce GET Configuration GET Loopback Status SET Error Forwarding ON/OFFSET Keep Alive Onoff SET Loopback OnoffOAM Configuration SET OAM ConfigurationSET Echo Onoff Clear System NameSET Exfo OAM Configuration SET OAM Mode ActivepassiveoffSET Discovery Mode Onoff SET Swap Address Mode OnoffAugust 7 Provisioning User and Privilege Settings Performance and AlarmsConfigure Alarm Thresholds Purpose GET UsersGET Temperature GET Network Optical Power GET Subscriber Optical PowerGET Optical Thresholds Clear Performance StatusReset ExitGET Inventory SET LED TestProvisioning August 7 AIWN-UM-7001-01 Specifications Appendix a Specifications August 7 AIWN-UM-7001-01 Product Support Appendix B Product Support August 7 AIWN-UM-7001-01 Glossary AIWN-UM-7001-01 GL-1Glossary August 7 GL-2 AIWN-UM-7001-01 Certification and Warranty World Headquarters For Technical Assistance