ADC Network Unit user manual COMMAND-LINE Interface CLI, Command Prompt

Chapter 3

COMMAND-LINE INTERFACE (CLI)

This section lists the commands used to operate the ENIU. After the initial installation of an ENIU, most testing and local operations are conducted with the Command Line Interface through a VT-100 compatible terminal. This terminal is connected to the front panel of the ENIU, and provides a standard EIA-232C interface.

Note: Command keywords are not case-sensitive.

COMMAND PROMPT

The CLI provides a prompt with a character indicating the user’s privilege level.

Table 3-1. CLI Command Prompts

Effective privilege	Prompt
RO	command $
RW	command %
SECURE	command #

SET-UP

The ENIU requires minimal set-up to provide OAM PDU reception, reporting, and remote loop-back functionality.

The ENIU is shipped with a power supply connector, and a serial communications cable. The user must provide network cables (Cat5e or better Ethernet cables for electrical interfaces or optical cables appropriate to the SFP for optical connections). A PC with HyperTerminal or equivalent is required with an available COM port for status monitoring. Follow these steps to connect the unit:

Step Action

1Connect Ethernet and/or optical cables to the desired equipment.

2Connect the serial communications cable to the Command port of the ENIU and to any COM port on the local PC.

3Launch HyperTerminal and configure it for 115200 bits per second, 8 data bits, 0 parity bits, 1 stop bit, and no flow control.

4Connect the power supply to the appropriate connector on the ENIU.

5Verify that the terminal displays a configuration screen.

AIWN-UM-7001-01 3-1