Chapter 3: Provisioning | August 7, 2006 |
Configure OAM for EXFO Operation Purpose:
Configure OAM to interoperate with EXFO test equipment in a VLAN environment. Note: In addition to configuring OAM extensions, this command also changes the MAC address from which OAM messages will be accepted from the slow protocols address to an ADC unique multicast address of 01:80:51:00:00:00.
Command:[RW, SECURE privilege]
SET EXFO OAM CONFIGURATION
Status Commands: [all privileges]
GET CONFIGURATION
Configure OAM Mode of Operation Purpose:
Configures OAM to operate in ACTIVE or PASSIVE mode or to turn OAM processing off. Command:[RW, SECURE privilege]
SET OAM MODE ACTIVEPASSIVEOFF
Status Commands: [all privileges]
GET OAM STATUS
Configure OAM Extensions Purpose:
Configure the individual OAM extensions that allow for OAM operation over a VLAN and for use with EXFO test equipment.
Command:[RW, SECURE privilege]
SET DISCOVERY MODE ONOFF
Turns on abbreviated discovery mode for use with EXFO test equipment.
SET SWAP ADDRESS MODE ONOFF
When on, forces ENIU to swap the source and destination addresses and recalculate the frame check sequence during loopback operations so that test frames can be returned directly to the sender.
SET UNICAST MODE ONOFF
When on, forces the ENIU to send OAM messages to the unicast address of the active mode OAM peer that is found during OAM discovery instead of sending messages to the slow protocols address.
SET VLAN MODE ONOFF
When on, allows the ENIU to discover VLAN tagged OAM protocol messages during OAM discovery and then use that tag to continue OAM protocol communications.
Status Commands: [all privileges]