Chapter 3: Provisioning | August 7, 2006 |
Configure Keep Alive Purpose:
Configure “keep alive” mode. When on, the ENIU will not generate an alarm event if the subscriber interface loses link. This allows the network side to remain unencumbered by interfaces changes that may occur on the subscriber port from random changes in the subscribers network.
Command:[RW, SECURE privilege]
SET KEEP ALIVE ONOFF
Status Commands: [all privileges]
GET CONFIGURATION
Configure Loopback Operation Purpose:
Configure Loopback settings and timeout values. The ENIU provides an extension to IEEE 802.3ah loopback operation by providing a timeout feature. When on, loopback operations will automatically end after the timeout period has elapsed and return the ENIU to normal state of passing data. Timeout values are specified in minutes ranging from 10 to 240 minutes or 0 to disable the timeout. The ENIU implements OAM and extended OAM methods of loopback operation as well as manual operation through the command line and a push button.
Command:[RW, SECURE privilege]
SET LOOPBACK TIMEOUT <minutes>
SET LOOPBACK ONOFF
Status Commands: [all privileges]
GET CONFIGURATION
GET LOOPBACK STATUS
Configure Error Forwarding Mode Purpose:
Configure Error Forwarding mode to on/off. The ENIU provides the feature to forward the frames received with errors to the other side for end to end testing. When on, frames received with errors are forwarded to the other side and when set to off, the frames received with errors are discarded. The default is off.
Command:[RW, SECURE privilege]
SET ERROR FORWARDING ON/OFF
Status Commands: [all privileges]