ADIC FastStor Mass Storage Device manual Rea y, 3 4 5 6

Page 23

The following illustration shows the layout of the LCD. The normal on-line message (LdR REAdY) is displayed on the top line. On-line, off-line, and error messages appear on this line.

DC indicates that data compression is selected on the drive.

WP indicates that a write-protected data cartridge is loaded into the drive.

CT indicates that the drive head needs to be cleaned.

The large numeric field in the center of the display normally indicates which cartridge is loaded into the drive. Whenever an error occurs an E will appear in this field and the error message will appear on line 1 of the display (see chapter 4 for descriptions of the possible error messages).

The Activity Bars on the right side of the display, in conjunction with the Activity LED, indicate robotic and drive activity. A blinking bottom bar is displayed when no activity is taking place. A slow interval between the bars appearing/disappearing indicates robotic activity, and a fast interval indicates drive activity.

The seven numeric fields at the bottom of the display indicate the current cartridge inventory. Each will appear only if a cartridge is present in the appropriate storage slot.

L r rea y

WP

DC 5

CT

1 2 3 4 5 6 7

Operator Panel LCD

Introduction7

Image 23
Contents FastStor Installation Operating GuideCopyright Adic 1997, 1998 Copyright NoticeCopyright 1997 Adic Europe Copyright Notice EuropeIC Notice Canada Only Regulatory NoticesFCC Notices USA Only Vcci Notices Japan Only EN 55022 Compliance Czech Republic OnlyCE Notice Declaration of Conformity Precautions Safety NoticesBlank Table of Contents Table of Contents Quick Start Guide LDR Scsi ID 1, DRV Scsi ID Power Button LCD indicates 1-7 loaded Scsi Cable Xvi Quick Start Guide Chapter Equipment Description Features Scsi Interface DLT DrivesOptions Connectors Switches and IndicatorsFastStor Series Front Panel 3 4 5 6 Rea yMode DLT Data Cartridge DLT MediaApplication Software Other RequirementsScsi Host Adapter Hardware Installation Unpacking and Inspecting Installing the Host AdapterChecking the Accessories FastStor Rear Panel Installing the Scsi Cable and TerminatorPreparing the Host Computer System Installing the Application SoftwareConnecting More than One FastStor Operation and Maintenance General Guidelines Powering on the SystemNormal Operations Rv init Setting the Scsi IDsPower Up Checks InitOperation and Maintenance Prepare and Install the Data Cartridges Close and Lock the Front Door Drive Status MessagesMode FastStor ModesSRC slot Mode 1A Load DRVLoa rv Ejecting Mode 1B Eject DRVEject rv SRC slot N Mode 2 Load SlotLoa slot Eject slot Mode 3 Eject SlotSt slot n Mode 4 Eject PckrEject pckr Fmt Mode 5 DensityEnsity Scsi Mode 6 SET Scsi IDSet scsi Cycle pwr Rv scsiRv I Cleaning Tape Normal MaintenanceCleaning the Drive Head It means You should Drive Head Cleaning ProcedureCleaning the Enclosure Troubleshooting and Diagnostics Loader and Drive Operational Problems Installation ProblemsSp l r fw Iag menuSp fw Sp rv fw Fw NnnnFp fw Nnnn Sp mtn fwMtn fw NN Sp fp fwSign on Sp T fwCycle Test Chg mo eCycleS Cycle TestRMV 2 Sel CleaningCt 2 Sel AC oN Enabling AutocleanDisabling Autoclean Using AutocleanSP cOUNTS AC OFFFrt pk ct UPG rv fw 000000XXRmv 2 sel Error Message Listing FastStor Error MessagesEnvironmental Considerations When You Call ADIC’S Technical Assistance CenterBlank Appendix Physical