ADIC FastStor Mass Storage Device manual EN 55022 Compliance Czech Republic Only, CE Notice

Page 5

EN 55022 Compliance (Czech Republic Only)

This device belongs to category B devices as described in EN 55022, unless it is specifically stated that it is a category A device on the specification label. The following applies to devices in category A of EN 55022 (radius of protection up to 30 meters). The user of the device is obliged to take all steps necessary to remove sources of interference to telecom- munication or other devices.

Pokud nenÌ na typovÈm ötitku poËÌtaËe uvedeno, ûe spad· do t¯Ìdy A podle EN 55022, spad· automaticky do t¯Ìdy B podle EN 55022. Pro za¯ÌzenÌ za¯azen· do t¯Ìdy A (ochrannÈ p·smo 30m) podle EN 55022 platÌ n·sledujÌcÌ. Dojde-li k ruöenÌ telekomunikaËnÌch nebo jinych za¯ÌzenÌ, je uûivatel povinen provÈst takov· opat¯enÌ, aby ruöenÌ odstranil.

CE Notice

Marking by the symbol indicates compliance of this tape library to the EMC (Electromagnetic Compatibility) directive of the European Community. Such marking is indicative that this tape library meets or exceeds the following technical standards:

EN 55022 — “Limits and Methods of Measurement of Radio Interference Characteristics of Information Technology Equipment.” This system is an EN 55022 Class B device.

EN 50081-1 — “Electromagnetic compatibility—Generic emmision standard Part 1: Residential, commercial, and light industry.”

EN 50082-1:1997 — “Electromagnetic compatibility—Generic immunity standard Part 1: Residential, commercial, and light industry.”

EN 61000-3-2 — “Harmonic current emissions test.” — Device Class A.

EN61000-3-3 — “Voltage fluctuations and flicker in low-voltage supply systems test.”

EN 61000-4-2 — “Electrostatic discharge immunity test.” — Severity level 3.

EN 61000-4-3 — “Radiated, radio-frequency, electromagnetic field immunity test.” — Severity level 2.

EN 61000-4-4 — “Electrical fast transient/burst immunity test.” — Severity level 2.

EN 61000-4-5 — “Surge immunity test.” — Severity level 2.

EN 61000-4-6 — “Immunity to conducted disturbances, induced by radio-frequency fields.” — Severity level 2.

EN 61000-4-8 — “Power frequency magnetic field immunity test.” — Severity level 2.

EN 61000-4-11 — “Voltage dips, short interruptions and voltage variations immunity test.” — Performance criteria B and C.

ENV 50204 — “Radiated electromagnetic field from digital radio telephones.”

EN 60950:1992 + Amd.1:1993 + Amd.2:1993 with considerations to Amd.3:1995 — “Safety of Information Technology Equipment including Electrical Business Equipment.”

A “Declaration of Conformity” in accordance with the preceding standards has been made and is on file at ADIC Europe, ZAC de Basses Auges, 1, rue Alfred de Vigny, 78112 Fourqueux, FRANCE.

VCCI Notices (Japan Only)

This is a Class B product based on the standard of the Voluntary Control Council for Interference for information technology equipment. If this equipment is used near a radio or television receiver in a domestic environment, it may cause radio interference. Install and use the equipment according to the instruction manual.

Note that VCCI regulations provide that changes or modifications not expressly approved by the tape library manufacturer could void your authority to operate this equipment.

Regulatory Notices

v

Image 5
Contents FastStor Installation Operating GuideCopyright Adic 1997, 1998 Copyright NoticeCopyright 1997 Adic Europe Copyright Notice EuropeIC Notice Canada Only Regulatory NoticesFCC Notices USA Only Vcci Notices Japan Only EN 55022 Compliance Czech Republic OnlyCE Notice Declaration of Conformity Precautions Safety NoticesBlank Table of Contents Table of Contents Quick Start Guide LDR Scsi ID 1, DRV Scsi ID Power Button LCD indicates 1-7 loaded Scsi Cable Xvi Quick Start Guide Chapter Equipment Description Features Scsi Interface DLT DrivesOptions Connectors Switches and IndicatorsFastStor Series Front Panel 3 4 5 6 Rea yMode DLT Data Cartridge DLT MediaApplication Software Other RequirementsScsi Host Adapter Hardware Installation Unpacking and Inspecting Installing the Host AdapterChecking the Accessories FastStor Rear Panel Installing the Scsi Cable and TerminatorPreparing the Host Computer System Installing the Application SoftwareConnecting More than One FastStor Operation and Maintenance General Guidelines Powering on the SystemNormal Operations Power Up Checks Setting the Scsi IDsInit Rv initOperation and Maintenance Prepare and Install the Data Cartridges Close and Lock the Front Door Drive Status MessagesMode FastStor ModesSRC slot Mode 1A Load DRVLoa rv Ejecting Mode 1B Eject DRVEject rv SRC slot N Mode 2 Load SlotLoa slot Eject slot Mode 3 Eject SlotSt slot n Mode 4 Eject PckrEject pckr Fmt Mode 5 DensityEnsity Scsi Mode 6 SET Scsi IDSet scsi Cycle pwr Rv scsiRv I Cleaning Tape Normal MaintenanceCleaning the Drive Head It means You should Drive Head Cleaning ProcedureCleaning the Enclosure Troubleshooting and Diagnostics Loader and Drive Operational Problems Installation ProblemsSp l r fw Iag menuSp fw Sp rv fw Fw NnnnMtn fw NN Sp mtn fwSp fp fw Fp fw NnnnSign on Sp T fwCycle Test Chg mo eCycleS Cycle TestRMV 2 Sel CleaningCt 2 Sel AC oN Enabling AutocleanDisabling Autoclean Using AutocleanSP cOUNTS AC OFFFrt pk ct UPG rv fw 000000XXRmv 2 sel Error Message Listing FastStor Error MessagesEnvironmental Considerations When You Call ADIC’S Technical Assistance CenterBlank Appendix Physical