Cisco Systems CTSMX20042K9 manual Calling someone by entering the URI, Search or Dial field 

Page 12

Cisco TelePresence System Profile Series, Codec C Series, Quick Set C20, MX200

Contents

Getting started

Placing calls

Using directories

In-call features

Settings

User guide

Contact us

Calling someone by entering the URI



	
Tap Call as outlined, if	Tap in the
needed.	Search or Dial field ().

This will produce the virtual keyboard.

Tap ABC to switch to the QWERTY keyboard

and tap 123 to switch to the numeric keyboard. Key in the number or URI ()

Berlin

Once the entire number or URI has been entered, tap the START button.

Tap END to terminate the call.

D14582.07 User guide Profile Series, Codec C Series, Quick Set C20, MX200, July 2011.	12	www.cisco.com
All contents are copyright © 2010–2011 Cisco Systems, Inc. All rights reserved.

Image 12

Contents Use with Cisco TelePresence Touch Administrator settings-Call settings Administrator settings-ResetWhat’s in this guide? History Searching Directory FavoritesGetting started Basics of the Touch Controller Scroll in listsAs outlined Selfview and camera control Tap Camera control to gainEntering Camera Control will Adding a near end camera preset For the new presetTap More then tap PressChanging an existing near end camera preset Tap Update to current positionRemoving an existing near end camera preset Tap More Then tap Tap the field to the rightTap Camera Control & Settings to open Camera whitebalance, exposure, and backlight compensationBacklight compensation improves Sound matters Ring tones and soundsDo not disturb Receiving callsPlacing calls Calling someone by entering the URI Search or Dial field Searching and calling an entry in any of the lists Calling an entry in one of the lists Then tap Favorites , Directory , or HistoryEntries, if needed Calling more than one Using Favorites Directory and History History DirectoryFavorites SearchingIn-call features Features in a call-an overview Layout lets you Change the layout Gain accessOn or off MultiSite onlyUser guide Calling participants to add them to an ongoing call Multiway Features when putting someone on hold Receiving another incoming callTransferring an ongoing call Select whom to transfer to in the usual wayNear end camera control Near end camera presets Using Touch Tones Dtmf in a callFar end camera control in a call only Sharing contents-conducting presentations Layout control Speaks gets Shown in frames Full screenMain frame. Identical sizes Nothing else is ShownSettings SettingsGaining access to the Settings Access the Settings as followsSystem Information Call Status Camera Control & Settings Ringtone & Sound Settings Administrator settings-Date, Time & Location Administrator settings-Call settings Administrator settings-IP settings for the codec Administrator settings-IP settings for the Touch controller Administrator settings-Pairing Administrator settings-H.323 settings An H.323 aliasGatekeeper discovery Manual or Automatic Administrator settings-SIP settings Administrator settings-Provisioning Administrator settings-Multiway Settings Administrator settings-EMC Resilience mode Administrator settings-Reset Contact us