Cisco Systems CTSMX20042K9 manual User guide

Page 20

Cisco TelePresence System Profile Series, Codec C Series, Quick Set C20, MX200

Contents

Getting started

Placing calls

Using directories

In-call features

Settings

User guide

Contact us

Calling participants to add them to an ongoing call (Multisite)

Calling more than one using Multisite is an optional feature that may, or may not, be present on your system. If in doubt, ask your System Administrator.

While in a call you may add participants provided that your system permits to do so. Tap Add ...

Repeat the procedure to include more participants, if needed.

The maximum number of participants possible will depend on the system used, consult your System Administrator, if in doubt.

Note that even voice-only participants may be added.

... then select, in the usual way, whom to add to the ongoing call.

Tap END to terminate the entire conference. To disconnect just one of the participants, tap the participant’s name along the bottom line and then tap END.

Once you have selected someone, tap Start to include this participant in the meeting.

D14582.07 User guide Profile Series, Codec C Series, Quick Set C20, MX200, July 2011.	20	www.cisco.com
All contents are copyright © 2010–2011 Cisco Systems, Inc. All rights reserved.

Image 20

Contents Use with Cisco TelePresence Touch Administrator settings-Call settings Administrator settings-ResetWhat’s in this guide? History Searching Directory FavoritesGetting started As outlined Basics of the Touch ControllerScroll in lists Entering Camera Control will Selfview and camera controlTap Camera control to gain Adding a near end camera preset For the new presetTap More then tap PressChanging an existing near end camera preset Tap Update to current positionRemoving an existing near end camera preset Tap More Then tap Tap the field to the rightBacklight compensation improves Tap Camera Control & Settings to openCamera whitebalance, exposure, and backlight compensation Sound matters Ring tones and soundsDo not disturb Receiving callsPlacing calls Calling someone by entering the URI Search or Dial field Searching and calling an entry in any of the lists Entries, if needed Calling an entry in one of the listsThen tap Favorites , Directory , or History Calling more than one Using Favorites Directory and History History DirectoryFavorites SearchingIn-call features Features in a call-an overview Layout lets you Change the layout Gain accessOn or off MultiSite onlyUser guide Calling participants to add them to an ongoing call Multiway Features when putting someone on hold Receiving another incoming callTransferring an ongoing call Select whom to transfer to in the usual wayFar end camera control in a call only Near end camera control Near end camera presetsUsing Touch Tones Dtmf in a call Sharing contents-conducting presentations Layout control Speaks gets Shown in frames Full screenMain frame. Identical sizes Nothing else is ShownSettings SettingsGaining access to the Settings Access the Settings as followsSystem Information Call Status Camera Control & Settings Ringtone & Sound Settings Administrator settings-Date, Time & Location Administrator settings-Call settings Administrator settings-IP settings for the codec Administrator settings-IP settings for the Touch controller Administrator settings-Pairing Gatekeeper discovery Manual or Automatic Administrator settings-H.323 settingsAn H.323 alias Administrator settings-SIP settings Administrator settings-Provisioning Administrator settings-Multiway Settings Administrator settings-EMC Resilience mode Administrator settings-Reset Contact us