Cisco Systems CTSMX20042K9 manual Calling more than one

Page 15

Cisco TelePresence System Profile Series, Codec C Series, Quick Set C20, MX200

Contents

Getting started

Placing calls

Using directories

In-call features

Settings

Calling more than one

User guide

Contact us

Calling several to initiate a video conference is an optional feature. If your system permits conferencing, you may set up a list of several participants and then call them all in one go. Ask your system administrator, if in doubt.

Enter a number or URI, or pick an entry from the Directory, the list of Favorites, or from the History.

Tap ADD PARTICIPANT as outlined to add			Locate the next to
the entry to the list of participants to be			be called.
called.

Tap Add participant again. The maximum number of participants permitted will depend on your system configuration. Ask your system administrator, if in doubt.

When all have been added (two in this example), tap START to call them all.

Tap END to terminate the entire conference. To disconnect just one of the participants, tap the participant’s name along the bottom line and then tap END.

D14582.07 User guide Profile Series, Codec C Series, Quick Set C20, MX200, July 2011.	15	www.cisco.com
All contents are copyright © 2010–2011 Cisco Systems, Inc. All rights reserved.

Image 15

Contents Use with Cisco TelePresence Touch History Searching Directory Favorites Administrator settings-Call settingsAdministrator settings-Reset What’s in this guide?Getting started Basics of the Touch Controller Scroll in listsAs outlined Selfview and camera control Tap Camera control to gainEntering Camera Control will Press Adding a near end camera presetFor the new preset Tap More then tapTap Update to current position Changing an existing near end camera presetTap More Then tap Tap the field to the right Removing an existing near end camera presetTap Camera Control & Settings to open Camera whitebalance, exposure, and backlight compensationBacklight compensation improves Receiving calls Sound mattersRing tones and sounds Do not disturbPlacing calls Search or Dial field  Calling someone by entering the URISearching and calling an entry in any of the lists Calling an entry in one of the lists Then tap Favorites , Directory , or HistoryEntries, if needed Calling more than one Using Favorites Directory and History Searching HistoryDirectory FavoritesIn-call features MultiSite only Features in a call-an overviewLayout lets you Change the layout Gain access On or offUser guide Calling participants to add them to an ongoing call Multiway Receiving another incoming call Features when putting someone on holdSelect whom to transfer to in the usual way Transferring an ongoing callNear end camera control Near end camera presets Using Touch Tones Dtmf in a callFar end camera control in a call only Sharing contents-conducting presentations Shown Layout controlSpeaks gets Shown in frames Full screen Main frame. Identical sizes Nothing else isSettings SettingsAccess the Settings as follows Gaining access to the SettingsSystem Information Call Status Camera Control & Settings Ringtone & Sound Settings Administrator settings-Date, Time & Location Administrator settings-Call settings Administrator settings-IP settings for the codec Administrator settings-IP settings for the Touch controller Administrator settings-Pairing Administrator settings-H.323 settings An H.323 aliasGatekeeper discovery Manual or Automatic Administrator settings-SIP settings Administrator settings-Provisioning Administrator settings-Multiway Settings Administrator settings-EMC Resilience mode Administrator settings-Reset Contact us