Cisco Systems CTSMX20042K9 Layout control, Speaks gets Shown in frames Full screen, Main frame

Page 26

Cisco TelePresence System Profile Series, Codec C Series, Quick Set C20, MX200

Contents

Getting started

Placing calls

Using directories

In-call features

Settings

User guide

Contact us

Layout control

This applies to multisite calls and to point-to-point calls with a presentation running.

You may alter the screen		... then tap Layout ...
layout when you are in a call.
To do this start by tapping
More ...

Takes you one	The	one who	The	one who	The	one	who	All participants are
menu level back	speaks get the		speaks gets the		speaks gets the			shown in frames
	full screen.		main frame. The		main frame. The			of identical sizes.
	Nothing else is		others are shown		others are shown
	shown.		as PiP (Picture in		as images below
			Picture).		the main frame.

... and finally select your preferred layout.

When a presentation is included in a call, all participants will be shown above the presentation, instead of below. This will provide a better feeling of eye contact.

Full screen will show the presentation only.

Observe that changes to this set of layouts made by the TC-console utility are not supported and will be ignored.

D14582.07 User guide Profile Series, Codec C Series, Quick Set C20, MX200, July 2011.	26	www.cisco.com
All contents are copyright © 2010–2011 Cisco Systems, Inc. All rights reserved.

Image 26

Contents Use with Cisco TelePresence Touch What’s in this guide? Administrator settings-Call settingsAdministrator settings-Reset History Searching Directory FavoritesGetting started As outlined Basics of the Touch ControllerScroll in lists Entering Camera Control will Selfview and camera controlTap Camera control to gain Tap More then tap Adding a near end camera presetFor the new preset PressChanging an existing near end camera preset Tap Update to current positionRemoving an existing near end camera preset Tap More Then tap Tap the field to the rightBacklight compensation improves Tap Camera Control & Settings to openCamera whitebalance, exposure, and backlight compensation Do not disturb Sound mattersRing tones and sounds Receiving callsPlacing calls Calling someone by entering the URI Search or Dial field Searching and calling an entry in any of the lists Entries, if needed Calling an entry in one of the listsThen tap Favorites , Directory , or History Calling more than one Using Favorites Directory and History Favorites HistoryDirectory SearchingIn-call features On or off Features in a call-an overviewLayout lets you Change the layout Gain access MultiSite onlyUser guide Calling participants to add them to an ongoing call Multiway Features when putting someone on hold Receiving another incoming callTransferring an ongoing call Select whom to transfer to in the usual wayFar end camera control in a call only Near end camera control Near end camera presetsUsing Touch Tones Dtmf in a call Sharing contents-conducting presentations Main frame. Identical sizes Nothing else is Layout controlSpeaks gets Shown in frames Full screen ShownSettings SettingsGaining access to the Settings Access the Settings as followsSystem Information Call Status Camera Control & Settings Ringtone & Sound Settings Administrator settings-Date, Time & Location Administrator settings-Call settings Administrator settings-IP settings for the codec Administrator settings-IP settings for the Touch controller Administrator settings-Pairing Gatekeeper discovery Manual or Automatic Administrator settings-H.323 settingsAn H.323 alias Administrator settings-SIP settings Administrator settings-Provisioning Administrator settings-Multiway Settings Administrator settings-EMC Resilience mode Administrator settings-Reset Contact us