Cisco Systems CTSMX20042K9 manual Administrator settings-Multiway Settings

Page 41

Cisco TelePresence System Profile Series, Codec C Series, Quick Set C20, MX200

Contents

Getting started

Placing calls

Using directories

In-call features

Settings

Administrator settings—Multiway Settings

All endpoints using the TC series software offers Multiway as a means of creating video conferences with more than just two participants.

Note that a successful use of Multiway requires the presence of certain infrastructure products and installations. If in doubt, consult your Cisco partner.

This page of the Settings offers the ability enter the path to the Multiway enabled MCU. This is required to make the Multiway functionality work.

User guide

Contact us

D14582.07 User guide Profile Series, Codec C Series, Quick Set C20, MX200, July 2011.	41	www.cisco.com
All contents are copyright © 2010–2011 Cisco Systems, Inc. All rights reserved.

Image 41

Contents Use with Cisco TelePresence Touch Administrator settings-Reset Administrator settings-Call settingsWhat’s in this guide? History Searching Directory FavoritesGetting started As outlined Basics of the Touch ControllerScroll in lists Entering Camera Control will Selfview and camera controlTap Camera control to gain For the new preset Adding a near end camera presetTap More then tap PressTap Update to current position Changing an existing near end camera presetTap More Then tap Tap the field to the right Removing an existing near end camera presetBacklight compensation improves Tap Camera Control & Settings to openCamera whitebalance, exposure, and backlight compensation Ring tones and sounds Sound mattersDo not disturb Receiving callsPlacing calls Search or Dial field  Calling someone by entering the URISearching and calling an entry in any of the lists Entries, if needed Calling an entry in one of the listsThen tap Favorites , Directory , or History Calling more than one Using Favorites Directory and History Directory HistoryFavorites SearchingIn-call features Layout lets you Change the layout Gain access Features in a call-an overviewOn or off MultiSite onlyUser guide Calling participants to add them to an ongoing call Multiway Receiving another incoming call Features when putting someone on holdSelect whom to transfer to in the usual way Transferring an ongoing callFar end camera control in a call only Near end camera control Near end camera presetsUsing Touch Tones Dtmf in a call Sharing contents-conducting presentations Speaks gets Shown in frames Full screen Layout controlMain frame. Identical sizes Nothing else is ShownSettings SettingsAccess the Settings as follows Gaining access to the SettingsSystem Information Call Status Camera Control & Settings Ringtone & Sound Settings Administrator settings-Date, Time & Location Administrator settings-Call settings Administrator settings-IP settings for the codec Administrator settings-IP settings for the Touch controller Administrator settings-Pairing Gatekeeper discovery Manual or Automatic Administrator settings-H.323 settingsAn H.323 alias Administrator settings-SIP settings Administrator settings-Provisioning Administrator settings-Multiway Settings Administrator settings-EMC Resilience mode Administrator settings-Reset Contact us