Black Box LWE100A-W1, LWE100AE-KIT, LWE100A-KIT-W1, LWE100A-KIT-W2 Hardware Installation

Page 11

Chapter 3: Hardware Installation

3. Hardware Installation

This chapter describes safety precautions and product information you have to know and check before installing the Wireless P-T-P Ethernet Extender.

3.1 Preparing for Installation

Read this chapter before installing the extender. It describes safety precautions and needed product information.

3.2 Professional Installation Required

Use a professional installer who is well trained in the RF installation and knowledgeable about local regulations.

3.3 Safety Precautions

To keep you safe and to install the hardware properly, read and follow these safety precautions.

1.If you are installing the Wireless P-T-P Ethernet Extender for the first time, for your safety as well as others’, use a professional installer who is trained on the safety hazards involved.

2.Keep safety as well as performance in mind when selecting your installation site, especially where there are electric power and phone lines.

3.When installing the Wireless P-T-P Ethernet Extender, note the following things:

NOTES:

Do not use a metal ladder;

Do not work on a wet or windy day;

Wear shoes with rubber soles and heels, rubber gloves, and a long-sleeved shirt or jacket.

4. When the system is operating, avoid standing directly in front of it. Strong RF fields are present when the transmitter is on.

3.4 Installation Precautions

Read and follow these installation precautions.

WARNING: EMD (Lightning) DAMAGE IS NOT COVERED UNDER WARRANTY.

1.Users MUST use a proper and well-installed grounding and surge arrestor with the Wireless P-T-P Ethernet Extender, otherwise, a random lightning could easily cause fatal damage to Wireless P-T-P Ethernet Extender.

2.Users MUST use the power cord and PoE injector shipped in the box with the Wireless P-T-P Ethernet Extender. Using other components will cause damage to the extender.

3.Users MUST power off the Wireless P-T-P Ethernet Extender first before connecting the external antenna to it. Do not switch from the built-in antenna to the external antenna via Web management without physically attaching the external antenna onto the Wireless P-T-P Ethernet Extender, otherwise, the extender might be damaged.

3.5 Hardware Installation Steps

3.5.1 Connect

1.On the bottom of the Wireless P-T-P Ethernet Extender is a movable cover. Grab the cover and pull it back gently to remove it as shown in Figure 3-1.

724-746-5500 blackbox.com

Page 11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Customer Support Information About This Manual Trademarks Used in this ManualTrademarks Used in this Manual Radio Frequency Interference Statements FCC and IC RFI StatementsNOM Statement Table of Contents Table of Contents Software SpecificationsSpecifications General Radio What’s Included Features Overview Overview IntroductionLWE100A Ethernet extender Components Typical ApplicationHardware Installation Hardware Installation Hardware Installation Extender Pole MountingHardware Installation Extender installed outdoors on a pole Using the External Antenna10. Connecting one end of the grounding wire Using the Grounding Wire11. Connecting the other end of the grounding wire Basic Settings Factory Default Settings Basic SettingsLogging Into the Web-based Interface System RequirementsMain Basic System SettingsBasic Settings Basic Settings Radius Settings Time SettingsFirewall Settings Destination IP filtering 11. Port forwarding 13. DMZ Basic Wireless Settings Basic Settings Site Survey VAP Profile Settings16. VAP Profile settings 18. Management Vlan ID Vlan TabAdvanced Settings Advanced Wireless Settings Advanced SettingsData Encryption and Authentication Settings Wireless Security SettingsAdvanced Settings Access Control Access Control Mode Access ControlWDS Settings Snmp Management ManagementManagement Remote Management Management Coovachilli Settings Backup/ Retrieve Settings Upgrade FirmwareRestore settings Restore Factory Default SettingsPassword Reboot10. Certificate settings Certificate SettingsMonitoring Tools System Log Monitoring ToolsSite survey Ping WatchdogAntenna Alignment Data Rate TestAntenna alignment Speed TestView Association List StatusStatus View Basic Information Association node details View Network Flow StatisticsView Active Dhcp Client Table View ARP TableView Bridge Table Dhcp client table View Network ActivitiesFrequently Asked Questions TroubleshootingTroubleshooting Shipping and Packaging Contacting Black BoxAppendix A. Ascii Appendix a AsciiAppendix B. SSH Settings Appendix B. SSH SettingsTable B-1 . CLI commands Appendix B. SSH SettingsCountry and wireless mode Mpdu Msdu Appendix B. SSH Settings Appendix B. SSH Settings Appendix B. SSH Settings Appendix B. SSH Settings License Version Blackbox.com Blackbox.com Black Box Tech Support FREE! Live /7
Top Page Image Contents