Cisco Systems D200 DLP-D239 Delete a Roll, DLP-D240 Cancel a Roll, Click the Circuits Rolls tabs

Chapter 19 DLPs D200 to D299

DLP- D239 Delete a Roll

DLP-D239 Delete a Roll

Purpose	This task deletes a roll. Use caution when selecting this option, traffic
	might be affected. Delete a roll only if it cannot be completed or cancelled
	in normal ways. Circuits might have a PARTIAL status when this option is
	selected. See Table 20-31 on page 20-77for a description of circuit
	statuses.
Tools/Equipment	None
Prerequisite Procedures	DLP-D60 Log into CTC, page 17-49
	NTP-D332 Bridge and Roll Traffic, page 7-9
Required/As Needed	As needed
Onsite/Remote	Onsite or remote
Security Level	Provisioning or higher

Step 1 From the View menu, choose Go To Network View.

Step 2 Click the Circuits > Rolls tabs.

Step 3 Click the rolled circuit that you want to delete.

Step 4 From the Tools menu, choose Circuits > Delete Rolls.

Step 5 In the confirmation dialog box, click Yes.

Step 6 Return to your originating procedure (NTP).

DLP-D240 Cancel a Roll

Purpose	This task cancels a roll. When the roll mode is Manual, you can only cancel
	a roll before you click the Complete button. When the roll mode is Auto,
	cancel roll is only allowed before a good signal is detected by the node or
	before clicking the Force Valid Signal button. A dual or single roll can be
	cancelled before the roll state changes to ROLL_COMPLETED.
Tools/Equipment	None
Prerequisite Procedures	DLP-D60 Log into CTC, page 17-49
	NTP-D332 Bridge and Roll Traffic, page 7-9
Required/As Needed	As needed
Onsite/Remote	Onsite or remote
Security Level	Provisioning or higher

Caution If you click cancel while performing a Dual roll in Manual mode and have a valid signal detected on both rolls, you will see a dialog box stating that this can cause a traffic hit and asking if you want to continue with the cancellation. Cisco does not recommend cancelling a dual roll when a valid signal has been detected. To return the circuit to the original state, Cisco recommends completing the roll, then using bridge and roll again to roll the circuit back.

	Cisco ONS 15454 SDH Procedure Guide, R7.2
19-44	October 2007