Step Connect your Coaxial-Cables/DSS Lines

Hookup and Installation

Step 7

Connect your Coaxial-Cables/DSS Lines

Your Belkin Power Console comes with three pairs of coaxial-cable connections to protect your system from dangerous electrical disturbances that can travel down your coaxial-cables lines. You will need additional coaxial cables to connect the Power Console to your home theater components.

1.Cable TV – Connect the incoming cable television coaxial-cable line to the connector labeled “Cable IN”. Connect one end of a second coaxial cable to the connector labeled “Cable OUT”. Connect the other end of this cable to your cable TV tuner.

2.Satellite (DSS) TV – Connect the incoming satellite television coaxial- cable line to the connector labeled “SAT IN”. Connect one end of a second coaxial cable to the connector labeled “SAT OUT”. Connect the other end of this cable to your satellite TV tuner.

3.Auxiliary – Connect the incoming TV or radio antenna cable line to the connector labeled “AUX IN”. Connect one end of a second coaxial cable to the connector labeled “AUX OUT”. Connect the other end of this cable to your TV or radio equipment.

Note: We have included labels for the Coax IN and Coax OUT lines if needed for better organization.

*IMPORTANT WARNING – To sufficiently safeguard all of your equipment from damage resulting from a power surge, all of your incoming coaxial-cable lines should be properly grounded. Contact a licensed electrician to verify that all of your cable lines are properly grounded to a cold water pipe or ground rod.

Belkin Power Console