Note:
The RangeLAN2 Access Point is shipped with Filter Fixed Nodes set to “Filtering” by default. Unless you are using an Ethernet Access Point (model 7510, 7520, or 7521) with revision 1.4 or greater of the Access Point flash code image installed, this param- eter must be set to “Not Filtering” in order for the Ethernet-ready device attached to the Ethernet Adapter to communicate with the wired network. For more information on this requirement, please refer to Chap- ter 11.
7.Your RangeLAN2 Ethernet Adapter is now ready for operation, and the Ethernet-ready device should be able to communicate with the wired and wireless network through the Ethernet Adapter.
If you cannot communicate between the Ethernet-ready device and the RangeLAN2 network, compare your network settings with the RangeLAN2 Ethernet Adapter’s default values. You may need to adjust the Ethernet Adapter’s software parameters. Please consult Chapter 5 for information on how to customize the configuration of the RangeLAN2 Ethernet Adapter and Chapter 11 for troubleshooting suggestions.
