Proxim 7920, 7921 manual Model 753x, operating in TB or Single-Ring SR/TB mode

Below is a summary for changing this parameter on each model:

Model 7500: Uncheck the NON-RangeLAN2 Address Filter on the Filter Configuration page of the 7500's Configuration Tool.

Model 7510/752x: No action is needed if the Access Point has revision 1.4 or greater of the flash code image installed. If the Access Point is using an earlier version of the flash code, set the Filter Fixed Nodes parameter to “Not Filtering” in the Filter Configuration Menu.

Model 753x, operating in TB or Single-Ring SR/TB mode:

There is no Filter Fixed Nodes parameter when operating the Token Ring Access Point in these bridging modes. Instead, you may configure the Access Point to forward packets destined for up to 3 MAC address prefixes in addition to the RangeLAN2 prefix. These MAC address prefixes may be set in the Hardware Filtering Configuration Menu.

Model 753x, operating in Multi-Ring SR/TB mode: Set the Filter Fixed Nodes parameter to "Not Filtering" in the Filter Configuration Menu.

51