Power Cable | Remote Control/ 1 Batteries (CR2025) | Cleaning Cloth | |
(Not available in all locations) | |||
|
|
LED Indications
:Light is On | :Light is Blinking | :Light is Off |
STAND
BY
LAMP TEMPInformation
If you press the POWER button on the remote control or projector, the screen appears within 30 seconds.
The projector is in normal operating condition.
This state appears when the projector is preparing an operation after the POWER button on the projector or the remote control has been pressed.
The POWER button is pressed to turn off the projector, and the cooling system is in operation to cool off the inside of the projector. (Operates for about 30 seconds.)
Refer to Action 1 below if the cooling fan inside the projector is not in normal operation condition.
Refer to Action 2 below if the lamp cover protecting the lamp unit is not closed properly.
This indicates that the lens cover does not open completely. Refer to Action 3 below.
This indicates that it has changed to Cooling mode, because the internal temperature of the projector has increased beyond the maintenance limit.
Refer to Action 4 below.
This indicates that the power is turned off automatically because the internal temperature of the projector has increased beyond the maintenance limit. Refer to Action 5 below
A problem has occurred with the operation of the lamp. Refer to Action 6.
Clearing Indicator Problems
Classification State
When the cooling fan
Action 1 system is not in normal operating condition.
When the lamp cover protecting the lamp unit is
Action 2 not properly closed or the sensor system is not in normal operating condition.
The status that the lens
Action 3 cover is not open completely.
This indicates that it has changed
Measures
If the symptom remains even after disconnecting and then reconnecting the power cord and turning the projector on again, contact your product provider or our service center.
Check if the screws on the side of the projector are correctly locked, and if they are locked normally, contact your product distributor or a service center.
Open the lens cover completely.
If the lens cover is not open completely while operating the projector, both the video and audio are turned off automatically.
If this status persists for ten minutes, the projector is turned off automatically.
If the internal temperature of the projector has increased beyond the maintenance limit, it is changed to Cooling mode before it is turned off automatically.