Samsung SP-L250, SP-L200, SP-L220 manual Remote Control Signal Receiver

Page 11

Action 4

Action 5

Action 6

to Cooling mode, because the internal temperature of the projector has increased beyond the maintenance limit.

If the internal temperature of the projector increases higher than the limit, it is turned off automatically.

The lamp

malfunctions after power turns off

abnormally or after powering on right after turning off the projector.

*Cooling mode: The fan speed has increased and the projector lamp has been changed to ECO mode.

Check whether the ventilating hole of the projector is blocked. Check the air filter and clean if blocked.

Check whether the surrounding temperature of the projector is higher than the standard temperature range of the projector.

Cool the projector sufficiently and operate it again.

Check whether the ventilating hole of the projector is blocked. Check the air filter and clean if blocked.

Check whether the surrounding temperature of the projector is higher than the standard temperature range of the projector.

Cool the projector sufficiently and operate it again.

If the same problem occurs continually, contact your product distributor or service center.

Turn the power off, wait for a sufficient amount of cooling time and then turn the power on to operate. If the same problem occurs continually, contact your product distributor or service center.

This Projector uses a cooling fan system to keep the unit from overheating. Operation of the cooling fan may cause noise, which does not affect the product performance and is part of normal operation.

Rear Side

1. PC OUT port		6.	[AV IN] S-VIDEO Input port
2. AUDIO OUT port		7.	[PC IN1,2] PC Input port
3. RS-232C port (For service input		8.	[PC IN1,2] AUDIO Input port
	terminals)
		9.	Remote Control Signal Receiver
4.	[AV IN] R-AUDIO-L Input port
		10.POWER Input port
5.	[AV IN] VIDEO Input port

Image 11

Contents Page Do not plug multiple devices into a single wall outlet Insert the power plug firmly so that it does not come looseDo not use loose power outlets or damaged power cables Under no circumstances touch the power plug with wet handsOperable Unplug the power plug before cleaning the productKeep the power cord away from heaters Do not disassemble, or attempt to fix or modify the product Place the product on the ground carefullyDo not drop the product while carrying it Keep the product out of children’s reachThere is a danger of fire or explosion Correct disposal of batteries in this product Europe only Make sure to place your remote control on a table or deskPage Front/Upper Side An optical engine adopting new LCD technologyUnpacking Lens coverLED Indications Clearing Indicator ProblemsRemote Control Signal Receiver Move PowerMenu VOL MuteReturn ExitIBM AV Timing VIDEO/S-VIDEO AV Timing D-Sub Format Resolution ScanZoom and Focus Adjustment Installing the ProjectorSelect Menu Setup Install Rear-Floor Select Menu Setup Install Front-FloorScreen Size and Projection Distance Leveling with Adjustable FeetScreen Connecting a PC using a D-Sub cable Resolution/Size Modes tableConnecting an External Monitor Connecting an AV device with component output Connecting an AV device using a D-Sub cableConnecting an External Speaker Connecting using a Video/S-Video cablePage Selecting an input source Turning on the projectorTurning off the projector Presentation Mode StandardMovie Mode DVD Combo Satellite STB 11 PC AV ReceiverColor Temperature Offset Gain Timing signalAuto Adjustment Coarse Fine Reset Usage Color PC menu Sharpness,Tint Zoom ResetLogo Blue Black Sound Language Menu OptionTransparency Low Medium High OpaqueOff 10 min 20 min 30 min Screen and External Source Installation and ConnectionMenu and Remote Control Defaultfrom the menu Lamp Replacement To clean the exterior and lens of the projectorClean the projector using a soft, dry cloth To clean the interior of the projectorPrecautions when replacing the projector filter Lamp Replacement ProcedureReplacing and Cleaning the Filter Location of the ventilation openings Ventilating openingsCIS Asia Pacific