Samsung Network Printer manual Ethernet speed, Click Network Settings Æ Reset

Page 18

3Configure an IP filter.

IP Filtering: You can enable or disable IP filtering.

IP Address1 ~ Address10: You can enter filtered IP addresses. Users having the IP addresses set here are able to access the network print server.

4Click Apply.

Only system administrators or authorised users can set, via SyncThru Web Service, IP addresses that can access the device. Up to 10 addresses or ranges of address choices can be made and set. Authorised users are able to change the action (Apply/ Undo) and to print to the network print server.

NOTE: Ranges of addresses shouldn't contain “null” or “0.0.0.0” values.

Reset

1Run your web browser and access SyncThru Web Service.

2Click Network Settings Æ Reset.

You can reboot the network print server, if your network settings are not applied correctly or the network card is disconnected from your network.

Ethernet speed

You can set the communication speed for Ethernet connections.

1Run your web browser and access SyncThru Web Service.

2Click Network Settings Æ General.

Speed Rate: Automatic, 10 Mbps(Harf Duplex), 10 Mbps(Full Duplex), 100 Mbps(Harf Duplex),

100 Mbps(Full Duplex). select a Ethernet speed from the drop-down list.

3Click Apply.

3.7

TCP/IP environment

Image 18
Contents Page Page Contents Appendix Federal Communications Commission FCC For products fitted with EU-approved radio devicesPlace and the system is fully assembled Introduction Package contentsGetting started Supported network environmentsComputer Requirements Installing your Network Printer CardSystem requirements IBMViewing the SyncThru Web Admin Service User’s Guide Installing softwareUninstalling software Programs supplied on the Network Utilities CDIP address setup Using SetIPUsing SyncThru Web Admin Service Using SyncThru Web Service Click Devices Æ Add deviceEnter your print server’s TCP/IP addresses and click Apply Using Snmp Configuring DHCP/BOOTPConfiguring Snmp TCP/IP environmentConfiguring Ddns Configuring SLPUsing SLP Dynamic DNS DdnsUsing UPnP Configuring WinsConfiguring UPnP BonjourPrinting protocols Standard TCP/IP portLPR port IPP port Configuring IPP in the print serverSamsung Printer Port Windows 2000/XP/2003Additional functions Click Network Settings Æ General ResetClick Network Settings Æ Reset Ethernet speedConfiguring NetWare NetWare environmentNetWare printing Adding a printer Printing in NetWareAdding a queue Assignments menuEtherTalk environment Configuring EtherTalkConfiguring the printer EtherTalk printingTCP/IP printing Bonjour printerWireless network environment OverviewBasic concept and terms WEP encryption Ieee 802.11 authenticationWPA Wi-Fi Protected Access IeeeSelect Network Settings Æ Wireless Before configuring the print serverWireless settings Status DescriptionWireless basic settings Wireless security settings Security Authentication Encryption method Method ModeNone Open System No encryption None security mode settings Static WEP security mode settingsEnhanced Security mode settings Using EAP-TLS Click ConfigureUsing WPA-PSK Select File Æ Add/Remove Snap-inUsing EAP-TTLS Items Specifications SpecificationsWireless specifications AppendixOpenSSL Statements OpenSSL LicenseDisclaimer Ad hoc peer-to-peer mode Bonjour BootpDdns Dhcp Http SLP Snmp UPnP Static WEP 6.4 WEP encryption Rev.1.00