Samsung SRP-500 ESC c 3 n, ESC c 4 n, Name Select paper sensorsto stop printing Format ASCll

ESC c 3 n

[Name]			Select paper detector(s)to output paper end signals
[Format]			ASCII		ESC		c	3	n
			Hex		1B		63	33	n
			Decimal		27		99	51	n
[Range]			0 ≤ n ≤ 255
[Description]			Selects paper detector(s) to output paper end signals,
			using n as follows:
Bit	Off/On	Hex		Decimal					Function
0	Off	00		0		Paper roll near end sensor disabled.
	On	01		1		Paper roll near end sensor enabled.
1	Off	00		0		Paper roll near end sensor disabled.
	On	02		2		Paper roll near end sensor enabled.
2	Off	00		0		Paper roll end detector disabled.
	On	04		4		Paper roll end detector enabled.
3	Off	00		0		Paper roll end detector disabled.
	On	08		8		Paper roll end detector enable.
4	-	-		-		Undefined
5	-	-		-		Undefined
6	-	-		-		Undefined
7	-	-		-		Undefined

[Notes]

•It is possible to select multiple detectors to output signals.

•Then, if any of the detectors detects a paper end, the paper end signal is output.

•Detectors are switched when executing this command.

•Because of this, the paper-out signal switching may delay depending on the receive buffer state.

[Default] n = 15

53

ESC c 4 n

[Name]			Select paper sensor(s)to stop printing
[Format]			ASCll		ESC		c	4	n
			Hex		18		63	34	n
			Decimal		27		99	52	n
[Range]			0 ≤ n ≤ 255
[Description]			Selects the paper sensor(s) used to stop printing when a
			paper-end is detected, using n as follows :
Bit	Off/On	Hex		Decimal					Function
0	Off	00		0		Paper roll near end sensor disabled.
	On	01		1		Paper roll near end sensor enabled.
1	Off	00		0		Paper roll near end sensor disabled.
	On	02		2		Paper roll near end sensor enabled.
2	-	-		-		Undefined
3	-	-		-		Undefined
4	-	-		-		Undefined
5	-	-		-		Undefined
6	-	-		-		Undefined
7	-	-		-		Undefined

[Notes]

•The printer goes off-line after printing stops.

•The paper roll near-end sensor is an option, therefore, if the paper roll near-end sensor is enabled by this command when the sensor is not equipped, it does not stop printing.

•The paper roll near-end sensor is enabled when either bit 0 or 1 is 1.

•The paper roll end sensor is a sensor which is always used to make an effective to stop printing.

[Default] n = 0

54