Samsung 731N manual Question, Answer

Page 31

If problems repeatedly occur, contact an authorized Service Center.

Q & A

Question

How can I change the frequency?

Answer

Frequency can be changed by reconfiguring the video card.

Note that video card support can vary, depending on the version of the driver used. (Refer to the computer or the video card manual for details.)

How can I adjust the resolution? Windows ME/XP/2000 : Set the resolution at the Control

 

Panel→Display→Settings.

 

* Contact the video card manufacturer for details.

How can I set the Power Saving

Windows ME/XP/2000 : Set the function at BIOS-SETUP of the

function?

computer or the screen saver. (Refer to Windows/Computer

 

Manual).

How can I clean the outer

Disconnect the power cord and then clean the monitor with a soft

case/LCD Panel?

cloth, using either a cleaning solution or plain water.

 

Do not leave any remains of the detergent nor scratch the case.

 

Do not allow any water to go inside the monitor.

Self-Test Feature Check

Self-Test Feature Check Warning Messages Environment Useful Tips

Your monitor provides a self test feature that allows you to check whether your monitor is functioning properly.

Self-Test Feature Check

1.Turn off both your computer and the monitor.

2.Unplug the video cable from the back of the computer.

3.Turn on the monitor.

If the monitor is functioning properly, you will see a box in the illustration below.

This box appears during normal operation if the video cable becomes disconnected or damaged.

4.Turn off your monitor and reconnect the video cable; then turn on both your computer and the monitor.

If your monitor screen remains blank after using the previous procedure, check your video controller and computer system; your monitor is functioning properly.

Warning Messages

Image 31
Contents SyncMaster 731N Notational Use only a properly grounded plug and receptacle Insert the power plug firmly so that it does not come looseDo not disconnect the power cord while using the monitor Do not use a damaged or loose plugKeep any heating devices away from the power cable Do not drop the monitor when moving itDo not place the product on the floor Do not spray water or detergent directly on the monitor Set down the monitor carefullyDo not place the monitor face down Keep the plastic packaging bag out of children’s reachDo not remove cover or back OthersNever insert anything metallic into the monitor openings Do not cover the vents on the monitor cabinetFalling product could cause physical damage even death Try to maintain a good posture when using the monitor Good Postures When Using the MonitorMonitor Driver Cable Sub Cable Power CordNatural Color software Custom For using a locking device, contact where you purchase it Monitor Assembly Attaching a Base Click Windows Installing the Monitor Driver ManualMicrosoft Windows XP Operating System Page Microsoft Windows NT Operating System How to install Click Start , Setting , Control PanelLinux Operating System How to install the Natural Color softwareNatural Color Software Program Page Auto Description MenuMenu Description Picture DescriptionPlay/Stop Brightness ContrastMenu Description Play/Stop Gamma Color Tone Color ControlCoarse Fine Sharpness Position Language Position Transparency Display Time Position displayImage Reset Color Reset Information Check List SymptomCan you see Check Signal Cable on the screen? SolutionsThere is no image on the screen Control Panel → Display → SettingsAnswer QuestionUseful Tips Signal Cable ResolutionInput Signal, Terminated Power SupplyEnvironmental considerations Dimensions WxDxH/ Weight Simple StandState Normal Operation Power saving mode Power Switch off Vesa Mounting InterfaceHorizontal Frequency Preset Timing ModesPixel Clock Sync Polarity Display Mode Frequency MHz KHz HorizontalLatin America North AmericaEurope Middle East & Africa Asia PacificHorizontal Frequency ResolutionDot Pitch Vertical FrequencyMéxico Suggestions for specific applications WarrantyWhat is Image retention ? Power Off, Screen Saver, or Power Save Mode