Samsung SF-515 manual Receiving in Auto mode, Receiving automatically in ANS/FAX mode

Page 37

Receiving in AUTO mode

1.Press Rcv.Mode/Contrast until the display shows ‘AUTO MODE’.

2.When you get a call, the machine answers it.

If a fax is being sent, the machine goes into receiving mode.

If the machine does not detect a fax signal, it will continue ringing to tell you it is a phone call. You should pick up the handset to answer the call, or it will switch to automatic receiving mode.

Receiving automatically in ANS/FAX mode

To use this mode, you must attach an answering machine to the extension telephone jack on the back of your machine (see page 1.6).

1.Press Rcv.Mode/Contrast until the display shows ‘ANS/FAX MODE’.

2.When you get a call, the answering machine answers it. If the caller leaves a message, the answering machine stores the message normally.

If your machine hears a fax tone on the line, the fax receive mode is activated.

Notes:

•If you have set your machine to ANS/FAX mode and your answering machine is switched off, or no answering machine is connected to your machine, the fax machine will automatically go into FAX mode after 10 rings.

•If your answering machine has a ‘user-selectable ring counter’, set the machine to answer incoming calls within 1 ring.

•If you are in TEL mode (manual reception) when the answering machine is connected to your machine, you must switch off the answering machine, or the outgoing message from the answering machine will interrupt your phone conversation.

Basic Operation 3.7

Image 37

Contents User’s Guide Trademark Notices Contents Making a copy Receiving a faxOther functions Automatic diallingMaintenance TroubleshootingImportant safety information Precautions Symbology Safety notesInstallation TAM lead * UK Only UnpackingFront view Control locations and functionsRear view Choosing a location Setting up your machineDocument tray Paper exit trayTelephone line Document exit trayExtension phone optional AC power cordInstalling the toner cartridge Installation Loading paper Insert the paper with the print side facing you Paper type and size Getting started One-touch dial Using the control panelSetup Entering alphanumeric characters Using the number keypadKeypad Character Assignments Editing numbers or name Entering numbersInserting pause Press Start/Enter when the name on the display is correct Setting up your fax number and namePress or ❿ until ‘TIME/DATE SETUP’ appears, then press Setting the time and dateEnter the correct time and date using the number keypad Ringer volume Adjusting volumeSpeaker volume Alarm volume/Key volumeBasic operation Preparing documents for faxing or copying Sending a faxResolution Setting document resolution and contrastContrast Loading document Sending a fax automatically Cancelling transmissionConfirming transmission Automatic redialReceiving modes Receiving a faxReceiving Manually in TEL Mode Receiving automatically in FAX modeDistinctive ring pattern detection Drpd Receiving automatically in ANS/FAX mode Receiving in Auto modeReceiving manually using an extension telephone Making a simple copy Copying overviewPress or ❿ to choose YES or no Advanced copy featuresPress Copy or Start/Enter to begin the copy operation To redial the number last called RedialTo search through redial memory Press and hold Redial/Pause for 2 secondsMonitoring a dual job status Sending a recallStoring a number for one-touch dialling One-touch diallingEditing a number for one-touch dialling Sending a fax using a one-touch numberIf you do not want to assign a name, skip this step Storing a number for speed dialling Speed diallingPress and hold Speed for 2 seconds Enter the number you want to store, then press Start/EnterEditing a number for speed dialling Sending a fax using a speed numberSearching sequentially through the memory Searching for a number in the memorySearching with a particular first letter Memo