Universal Remote Control URC-WR7, OCE-0085A Erasing Commands Overview, Component Buttons Enter

Erasing Commands -

Overview

You can erase a single learned command, all learned commands in each component mode, SimpleSound programming, MacroPower com- mands, or re--set the remote to original factory default settings.

Erasing a Single Learned Command from One Component

STEP 1: Press the component button where the learned command is stored and the [ENTER] button at the same time for two seconds until the component LED light turns on.

IMPORTANT: You have 30 seconds to per- form the next step while you are in programming mode. If you do not press a button within 30 sec- onds, the component LED light will turn off. The remote will exit the programming mode and you will have to start over.

COMPONENT

BUTTONS

ENTER

STEP 2: Press and hold the button you want to erase for two seconds. The compo- nent LED light will blink twice to confirm the erasure.

STEP 3: Repeat Step 2 to erase any other buttons in the selected component mode.

STEP 4: To exit Erase mode, press and hold both the component button and the [ENTER] button at the same time until the component LED light blinks three times.

Page 30