Arcam E-2 manual Unable to adjust bass and treble controls, Unable to adjust balance control

Page 29

Unable to adjust bass and treble controls:

Bass and treble is not available in THX mode. For Analogue Stereo and Digital Stereo modes, check that the ‘Auto Stereo Tone Bypass’ line of ‘Speaker Eq’ in the Setup Menu is set to No.

Unable to adjust balance control:

Balance is not available in THX mode.

Digital signal drops out when other electrical appliances turn on (heating, fridge, freezer, etc.):

If a poor quality or incorrect type of cable has been used for the digital inputs, they can pick up electrical noise. Change the cable to a 75Ω low loss coaxial type.

Check the connections have not oxidised. Clean the connectors with contact cleaner if they appear oxidised.

English

E-29

Image 29

Contents Page Safety Compliance Safety guidelinesImportant Safety Instructions Welcome to the AV8 Preamp Processor ContentsPositioning the Unit InstallationVideo AudioCables Speaker InstallationAnalogue Audio Inputs Audio ConnectionsAnalogue Record Outputs Digital Audio Inputs Digital OutputVideo Connections Zone 2 ConnectionsControl Connections RGB 4-wire connectionTrigger Outputs High Quality Component Video ConnectionsWrong PLUG? Connecting to a Power SupplyMains Lead PluggingConfiguring the AV8 Speaker Sizes Basic SetupGeneral Settings Level Settings Speaker Delay SettingsSubwoofer Settings Distance measurements for 5.1 Speaker delay settingsSaving Settings and Exit Setup THX SettingsSave Setup Boundary Gain CompensationADV 2 Video Settings Advanced SetupADV 3 Digital Settings ADV 1 Speaker EQADV 5 Input Trims ADV 4 Zone 2 SettingsEnabled sources are listed on the ‘Access’ line of the OSD Saving Settings and Exiting Setup THX. Selects between the available THX modes Front panel controlsSource selection Remote controlOperating your AV8 Using the ControlsHeadphones Volume ControlStereo Direct EFFECTS/FXUsing the Main Menu Screen Pro Logic II Music Mode Different volume level from the main zone zone Using ZoneCR80 remote control Control VIA Zone 2 MenuTWO-CHANNEL Source Modes Surround modesIntroduction THX Modes Multichannel SourcesMultichannel Source Modes About THX Cinema Processing DSP Effects ModesTHX Technology THX StandardsTroubleshooting Unable to alter settings in Setup Menus Source switching changes randomly or freezes on one sourceFeedback when making digital recording No zone 2 audio when playing DTS filmBalance is not available in THX mode Unable to adjust bass and treble controlsUnable to adjust balance control Continual Improvement Policy Technical specificationsLocking the Setup Menu Processing Component SpecificationsAdditional technical information Radio InterferenceScart S-video cable with audio back to processor Scart ConnectionsScart RGB cable with audio back to processor Example for programming Display = RC-5 code IR Remote CodesTable of Remote Codes Command Processing Setting ValuesQuery Commands MUT PWREFF ?EFF THX ?THXMain Menu Commands General Operation CommandsBasic Delay Setup Commands BasicBasic General Basic SpeakersBasic THX Basic SubSetup Commands Advanced Menu Access Engineering SettingsMulti-button Presses NavigationAV8 Programmer Utility SoftwareWorldwide Guarantee GuaranteeWarranty Covers Claims Under Guarantee