Appendices69
Appendix D: Programming the Remote Control, continued
Programming the Remote Control
1.Move the slide switch at the top of the remote to the position for the product you want to control. Refer to the table below. Only one of each device type can be controlled in each
Switch Position | Affected Device |
Cable/SAT | Cable Box |
| DTV Receiver |
| Satellite Receiver |
|
|
VCR | VCR |
| DVR |
| Laser Disc Player |
| DVD Player/Recorder |
|
|
DVD | DVD Player/Recorder |
| DVR |
| Laser Disc Player |
| VCR |
|
|
Audio | A/V Receiver |
| Audio Amplifier |
| CD Player |
|
|
2.Press and hold POWER on the remote control for several seconds until the key blinks twice and goes off.
3.Release the POWER key.
4.Enter the first
•The POWER key blinks twice when you start to enter the code and then once for each addi- tional keypress.
•The POWER key blinks twice when you finish entering a valid code.
•Move the slide switch to another position if you need to start over or wish to exit programming mode.
5.Point the remote control at the equipment and press POWER. If the product has no power on/off function, press a different key, such as (Play),
(Stop), VOL , or MUTE.
•If the equipment responds, the remote control is properly programmed to operate the equip- ment.
•If the equipment does not respond, repeat steps
IMPORTANT
You may need to reprogram the remote control after changing the batteries.
6.Once you have found the correct code, write it in the space below for future reference.
Switch Position | Device Type | Code |
CABLE/SAT |
|
|
|
|
|
VCR |
|
|
|
|
|
DVD |
|
|
|
|
|
AUDIO |
|
|
|
|
|
Code Verification
To determine the code programmed for any position of the slide switch:
1.Move the slide switch to the position you wish to verify.
2.Press and hold POWER on the remote control for several seconds until the key blinks twice and goes off.
3.Press keys 9 9 0
4.Press 1 and count the blinks of the power key. Write down the number of blinks as the first digit of the code.
5.Repeat step 4 for the second, third, fourth, and fifth digits of the code.
Audio Lock: Universal A/V Receiver Control
With Audio Lock active, the remote control operates the volume and mute functions of the A/V receiver in all positions of the slide switch. Activate Audio Lock if you normally use an A/V receiver with your TV and other A/V equipment.
1.Program the AUDIO position for your A/V receiver as described earlier in this section.
2.Move the slide switch to the AUDIO position.
3.Press and hold POWER on the remote control for several seconds until the key blinks twice and goes off.
4.Press keys 9 9 3 ENTER
The POWER key will blink twice to indicate Audio Lock is active.
To Reset the Remote Control to Operate Volume and Mute for the TV Speakers
1.Press and hold POWER for several seconds until the key blinks twice and goes off.
2.Press keys 9 9 3 VOL.
The POWER key will blink four times to indicate Audio Lock has cleared.