Mitsubishi Electronics DX-TL4U manual Appendix C Troubleshooting, Problem Possible Solution

Page 87

Four-Channel Digital Video Recorder

Appendix C — Troubleshooting

Problem

 

Possible Solution

No Power

y

Check power cord connections.

y

Confirm that there is power at the outlet.

 

 

y

Check camera video cable and connections.

 

y

Check monitor video cable and connections.

No Live Video

y

Confirm that the camera has power.

 

y

Check camera lens settings.

 

y

Check CVBS/VGA switch settings.

 

 

Live Video Very Bright

If a cable is attached to the “Loop” connector, make certain it

is connected to a properly terminated device.

 

 

 

DVR has stopped recording

If hard disk drive is full, you will either need to delete video or

set the DVR to the Overwrite Mode.

 

 

 

DVR displays an error

The DVR will automatically reset the time and date of the

unit, according to the time and date of the last recorded image.

message stating that the last

If this is not the correct time and date, reset the time and date

recorded image date and time

manually. If the correct time and date is earlier than the last

is later than the current date

recorded image, any video with a later time and date will be

and time setting of the DVR.

lost when resetting the correct time and date.

 

 

 

 

77

Image 87
Contents Page Page Compliance Notice of FCC Cleaning Important SafeguardsTable of Contents Clip Copy Load Default Setup OSD On-Screen Display Setup Main Monitoring Setup ScreenPTZ Mode Digital Zoom Mode Load / Save Setup Clear All DataList of Illustrations Alarm In Event Action Record setup screen User’s Manual Viii Introduction FeaturesTechnical Overview Connecting the Video Source InstallationPackage Contents Required Installation ToolsConnecting the Loop Through Video Connecting AudioSetting Unit for Cvbs or VGA output Connecting the Monitor Connecting AlarmsConnecting the Spot Monitor Connecting to the Network Port AI 1 to 4 AlarmAlarm Out Factory Reset Connecting to the RS-232C PortConnecting the Power Cord Connecting to the USB PortFront Panel Controls ConfigurationPanic Button Infrared Remote Control Connecting the Infrared Remote ControlTurning on the Power Initial Unit SetupSetup Screen Four-Channel Digital Video Recorder System Information Normal Setup ScreenSystem Information Change screen System Upgrade screen Date/Time setup screen Holiday Setup screen Four-Channel Digital Video Recorder System Check Config. screen System Check Alarm Out / Notify screen M.A.R.T. Setup screen System Log screen Camera Setup Screen Configuring Input DevicesPTZ Device list Motion Detector setup screen Text-In Setup screen Text-In Generic Text Setup screen Alarm Out setup screen Alarm Out Schedule screen RS232 setup screen Record Mode Setup Screen Configuring Recording SettingsTime-Lapse Record Setup screen Time-Lapse Recording Schedule screen Pre-Event Record Setup screen Alarm In Event Action Record Setup Screen Event Action SetupAlarm In Event Action Alarm Out setup screen Motion Detector Event Action Record setup screen Motion Detector Event Action Alarm Out setup screen Text-In Event Action Record setup screen Text-In Event Action Alarm Out setup screen Video Loss Event Action Record setup screen Video Loss Event Action Alarm Out setup screen OSD On-Screen Display Setup Display SetupFour-Channel Digital Video Recorder Main Monitoring Setup screen Network Setup Screen LAN Manual Setup screen LAN Setup ScreenPort Number Setup screen LAN Dhcp Setup screen Modem Setup screen Dvrns Setup screen Callback Center LAN Setup screen Callback Center Modem Setup screen Password setup screen Password Setup ScreenClip Copy Config ScreenUSB Flash Memory Disk Partition Selection screen Load / Save Setup screen Load / Save SetupUser’s Manual Live Monitoring OperationLive Monitoring Text-In screen PTZ ModePTZ Menu Recording Video Preset Apply screenPlaying Recorded Video Recording AudioArrow Buttons Digital Zoom screen Searching VideoDate/Time Search screen Date/Time SearchEvent Log screen Event Search by Event screen Text-In Log screen User’s Manual Preparing the USB-IDE hard disk drive in Windows Appendix a USB Hard Disk Drive PreparationUser’s Manual Query Example Appendix B Text-In Query ExamplesQuery Example Problem Possible Solution Appendix C TroubleshootingInput Output Appendix D Connector Pin OutsAppendix E Map of Screens Video Appendix F SpecificationsStorage Weee Waste Electrical & Electronic Equipment