Hyundai P224WK manual U.S.A

Page 2

U.S.A.

U.S.A.

U.S.FEDERAL COMMUNICATIONS COMMISSION RADIO FREQUENCY INTERFERENCE STATEMENT INFORMATION TO THE USER

NOTE : This equipment has been tested and found to comply with the limits for a Class A digital device pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet of a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/Monitor technician for assistance.

Changes or modification not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Connecting of peripherals requires the use of grounded shielded signal cables.

Image 2

Contents Page U.S.A EN60065 EN55022 1998+A1 2000 +A2 2003 CLASS A DECLARATION OF CONFORMITYAll of Digital sigange HYUNDAI IT provides EN55024 1998+A1 2001 +A2 EN 61000-3-2 2000 +A2DIGITAL SIGNAGE ContentsMajor features Safety Information The main plug of the power supply cord shall remain readily operable Do not hang on or jump to the product or mounting rack Be sure to understand Image quality of the productBase Frame Type Remote control & batteriesCheck the product list Users manualProper location for product installation Title and function of each part Control Panel3 4 6 7 9 ! # % Terminal panel5 8 0 @ $ 10/36 Remote controlHow to insert batteries Satellite receiver How to Connecting Kiosk11/36 How to Connecting Digital RGBHDMI Horizontal frequency ResolutionSupport timing for HDMI Vertical frequencyHow to Connecting analog RGB PC D-SUB 14/36Support timing for PC How to Connecting the component Option 16/36Resolution Support timing for component & AVHow to Connecting the the video Option 18/36Adjusting OSD and explanation of its function How to Select the Picture ModeHow to Set the Desired Picture 20/36How to Select a Colour Tone 21/36How to Set the Display Size 22/36How to set image adjustment in PC mode Supported only in PC mode 23/36ReductionNR How to Set NoiseHow to Select the Audio ModeHow to Adjust the Desired Audio Mode 26/36 How to Select Auto VolumeHow to Select Sound Mode 27/36 How to ResetHow to Set Clock,Sleep Time, ON/OFF Time Choosing the Your Languages 28/3629/36 How to set OSD toneHow to Set Key-Lock How to Set the Multi Function Example of installation install 3x2 with 6 unitsSet up Value How to Set the Heat Control 32/36Diagnosis If the batteries are drained, replace them with new batteries 34/36of speaker cable the system as it supports Plug and PlayPower SpecificationsRecommended resolution D320MLI/G/D400ML D420MLI/G/P/T D460MLI/G/P/T/HD405MLI/G/D407MLI/G/P/T 1. SPEED 9600 Baud/s, 8 bit, No parity, 1 Stop bit REMOTE CONTROL / RS232C COMMAND SPEC2. REMOTE CONTROL WAVE FORM To power off set that is SET ID COMMAND TYPECommand example To factory reset all setDescription 5. COMMAND TYPECommand 7. REMOTE CONTROL KEY CODE TABLE Key valueHYUNDAI IT Service Center