JVC XV-DDV1SL Easy & simple setup, Presetting the built-in TV tuner, Automatically-Auto Setup

INITIAL SETTINGS 13

Easy & simple setup

Presetting the built-in TV tuner

1Turn on the power.

Press STANDBY/ON on the unit or on the remote control.

• The AUTO SET/T-V LINK screen appear on the TV.

automatically—Auto Setup

Before starting, make sure of the following:

•The TV aerial cable is connected firmly to the unit.

•The AC power cord is plugged in.

•An appropriate input (AV) mode is selected on the TV.

First time you turn on the power, the unit automatically shows the Auto Setup screen. Store the TV stations (programme positions), clock time and Guide Program numbers using this screen first.

When using the remote control, slide the DVD/TV/ HDD selector to the right (HDD), then ENTER.

12

2Start Auto Setup.

Press 5 or ° to move to “AUTO SET,” then press ENTER or 3.

•AUTO SET screen appears. As Auto Setup progresses, the “ ” mark on the TV moves from left to right. (“Au To” starts flashing in the display window.)

•When Auto Setup is completed, “SCAN COMPLETED” appears for about 5 seconds. The display window shows the clock time, “1” (lowest programme position number) or “– –:– –” in sequence as illustrated on page 15.

[ENTER] [SET UP]

[SET UP]

BeginningEnd

1

2

NOTE

If you have connected the unit to a TV offering T-V Link via a 21-pin SCART cable, the unit starts “TV-linked Setup” (see page 14) even if you have selected “AUTO SET.”

Once you have performed Auto Setup correctly, all the stored TV stations and their Guide Program numbers will be kept in memory and the unit will not perform Auto Setup again.

•If a power failure occurs, set the clock manually (see page 69).

•If you move to a different area, or if a new station starts broadcasting in your area, perform tuner setting manually (see page 70).

NOTES

•Where no TV station transmits Programme Delivery Control (PDC) signals, the unit cannot set up the clock time and Guide Program numbers automatically.

•The unit memorizes all detected stations even if their signals are very weak. You can delete these stations with poor picture quality later manually (see “To delete a station” on page 71).

•If a power failure occurs, or if you turn off the power while Auto Setup is in progress, Auto Setup will be interrupted. If this happens, turn off the power and try again from the beginning.

•Auto Setup may fail or stored information may be incorrect if received signals are weak.

•If you press any button on the unit or on the remote control while Auto Setup is in progress, it will be cancelled.