JVC XV-DDV1SL, LET0239-001A manual Start playback on the VCR Start recording on the HDD deck

85

Connection to the L-2 IN connector with the SCART cables

XV-DDV1SLTV

		DVD/HDD		DVD	L-1	IN/OUT	IN
DVD DIGITAL OUT		VIDEO	AUDIO	VIDEO SIGNAL
		OUT	OUT	SELECTOR
PCM / STREAM		VIDEO	LEFT			SAT
COAXIAL	OPTICAL			COMP. Y/ C	L-2	IN
				/ RGB
							OUT
						AV	ANTENNA
		S-VIDEO	RIGHT			COMPU

21-pin SCART cables (not supplied)

VCR

The HDD deck is not compatible with RGB signal input. So do not connect an RGB component to the L-2 IN connector (or do not set the signal output mode of the connected component to RGB signal).

When connecting the VCR to the L-1 IN/OUT connector:

TV				XV-DDV1SL
		DVD/HDD		DVD		L-1	IN/OUT	IN
DVD DIGITAL OUT		VIDEO	AUDIO	VIDEO SIGNAL
		OUT	OUT	SELECTOR
PCM / STREAM		VIDEO	LEFT				SAT CONTROL
COAXIAL	OPTICAL			COMP.	Y/ C	L-2	IN
				/ RGB
								OUT
							AV	ANTENNA
		S-VIDEO	RIGHT				COMPU LINK

S-video cable (not supplied)

21-pin SCART cables (not supplied)

VCR

S-Video cable connection is required only when the VCR is not compatible with S-Video, but the TV is compatible.

Precaution before editing onto the HDD

The picture shown on the TV is a few seconds behind the scene currently recorded onto the HDD. Therefore, if you start recording at the desired scene on the TV, you will miss the beginning of the scene by a few seconds. On the other hand, when you stop recording, you will record some extra scenes.

To use the HDD deck for the recording component:

1Make connections

Connect the VCR through the L-2 IN (or L-1 IN/OUT) connector on the rear using the 21-pin SCART cable (not supplied).

•When using the L-2 IN connector, set “L-2 SELECT” to “A/V” (see page 68).

•If both the external VCR and the TV are compatible with S-Video signal:

Set “L-1 OUTPUT” or “L-2 INPUT” to “S-VIDEO” (see page 68).

2Select the HDD deck.

On the remote control

Set the DVD/TV/HDD selector set to the right (HDD), then press ENTER (or LIVE).

On the unit

Press DVD/HDD so that the HDD lamp lights.

3Select the input mode on the HDD deck.

On the remote control

Press AUX (number button “0”) and/or HDD/TV PR +/– to select “L-2” for the L-2 IN connection, or “L-1” for the L-1 IN/OUT connection.

On the unit

Press PR +/– to select “L-2” for the L-2 IN connection, or “L-1” for the L-1 IN/OUT connection.

NOTE

When connecting a TV with TV-Link or with equivalent function (see page 15) using the SCART cable, select “OFF” for “DIRECT REC” (see page 67) in order to record S-Video signals through the L-2 IN connector.

4Start playback on the VCR.

• Refer to the instruction manual supplied with the VCR.

5Start recording on the HDD deck.

On the remote control

Press and hold REC ¦, then press 3.

On the unit

Press ¦ (record).

The lamp next to the ¦ (record) button lights.

NOTE

For Y/C signal input/output, be sure to use a 21-pin SCART cable that is compatible with the Y/C signal.