JVC LET0239-001A, XV-DDV1SL manual PCM only, Normal, Low

78		CHANGING THE INITIAL SETTING (cont.)
AUDIO
	Set this correctly according to the external component connected to the DIGITAL OUT
	connectors on the rear.
DIGITAL AUDIO	• See “Digital output signal chart” on page 92 for details about the relation between the
	setting and output signals.
OUTPUT
Setting options	• PCM ONLY:	Select when connecting to the linear PCM digital input connector
		of other audio equipment such as an MD recorder.
•PCM ONLY
	• DOLBY DIGITAL/PCM: Select when connecting the digital input connector of a Dolby
•DOLBY DIGITAL/
		Digital decoder or an amplifier with a built-in Dolby Digital
PCM
		decoder.
• STREAM/PCM
	• STREAM/PCM:	Select when connecting the digital input connector of an
		amplifier with a built-in DTS, MPEG Multichannel or Dolby
		Digital decoder, or the stand-alone unit of such a decoder.
	To correctly play the audio in a DVD Video disc recorded with surround multichannel audio,
	set this properly according to your audio system configuration.
	• DOLBY SURROUND: Select when listening to multichannel surround audio through a
ANALOG DOWN		surround decoder connected to the DVD/HDD AUDIO OUT and
		L-1 IN/OUT connectors on the rear.
MIX
	• STEREO:	Select when listening to conventional two-channel stereo audio
Setting options
		through an amplifier or receiver connected to the DVD/HDD
•DOLBY		AUDIO OUT and L-1 IN/OUT connectors on the rear.
SURROUND		You can also connect a MiniDisc recorder, cassette deck, etc. to
• STEREO		record through the DVD/HDD AUDIO OUT (and L-1 IN/OUT)
		connectors on the rear.
	NOTE
	This function does not take effect when 3D PHONIC is activated.
D. RANGE	This setting provides optimal audio quality through the DVD/HDD AUDIO OUT and L-1 IN/
	OUT connectors on the rear, for listening to DVD Video discs recorded in Dolby Digital
CONTROL
	format, at low or middle volume.
Setting options
	• WIDE RANGE:Select to enjoy powerful playback sound with the widest dynamic range.
•WIDE RANGE
	• NORMAL:	Normally, select this.
• NORMAL
	• TV MODE:	Select if DVD Video disc sound level is lower than TV programme sound
•TV MODE
		level. Thus you can hear sound at a lower volume clearly.
OUTPUT LEVEL	This setting allows you to attenuate the level of the signal output through the DVD/HDD
Setting options	AUDIO OUT and L-1 IN/OUT connectors on the rear.
• STANDARD	• STANDARD:	Normally, select this.
•LOW	• LOW:	Select if the reproduced sounds are distorted.