JVC LYT1300-001A manual 40 EN, To hear the dubbed sound during playback…

40 EN USING THE REMOTE CONTROL UNIT (cont.)

Audio Dubbing (DV mode only)

The audio track of a tape recorded in DV format can be customised only when recorded in the 12-bit and SP modes. ( pg. 27)

Microphone

Speaker

Audio cable (provided)

Open the cover.

1Play back the tape to locate the point where editing will start, then press PAUSE (9).

2While holding A. DUB (D) on the remote control, press PAUSE (9). The “9D” and “MIC” indicators appear.

3Press PLAY (U), then begin “narrating”. Speak into the microphone.

● To pause dubbing, press PAUSE (9).

4To end Audio Dubbing, press PAUSE (9), then STOP (8).

To hear the dubbed sound during playback…

Set “DV NARR.” to “ON” or “MIX”. ( pg. 26, 27)

NOTES:

●When editing onto a tape that was recorded at

12-bit, the old and new soundtracks are recorded separately.

●If you dub onto a blank space on the tape, the sound may be disrupted. Make sure you only edit recorded areas.

●If feedback or howling occurs during TV playback, move the microphone away from the TV, or turn down the TV’s volume.

●If you change from 12-bit to 16-bit in mid- recording and then use the tape for Audio Dubbing, it is not effective from the point where 16-bit recording began.

●During Audio Dubbing, when the tape moves to scenes recorded in the LP mode, scenes recorded in 16-bit audio or a blank portion, Audio Dubbing stops.

●To perform Audio Dubbing while watching on the television, make connections. ( pg. 18)

●To perform Audio Dubbing with a video unit connected to the player’s S, AUDIO(L/R), VIDEO connector, first set “S/AV INPUT” to “ON” in VIDEO Menu. ( pg. 26, 27)

The “AUX” indication appears instead of “MIC”. However, you cannot hear the sound from the connected device through the headphones.