Creating realistic sound fields
Adjusting the sound
On the remote control:
1 Press TEST.
Check if you can hear the sounds through all the speakers at the equal level.
“TEST TONE” and the corresponding signal indicator starts flashing on the display window, and the test tone comes out of the speakers in the following order;
] Front left speaker (a) ] Center speaker (b) ] Front right speaker (c) ] Surround right speaker (i) ] Surround left speaker (g) ] (back to the beginning)
2 Adjust the speaker output levels (–10 to +10).
Adjust the center speaker and surround speaker levels as much as the sound from the front speakers. Use one of the following buttons to adjust each speaker level.
•CENTER +/– for the center speaker
•
•
3 Press TEST again to stop the test tone.
7For DAP modes (A pg. 29) only
4 Press EFFECT to select the effect level (1 to 5) you want.
Each time you press the button, the effect level changes as follows;
]DSP EFFECT 1 ] DSP EFFECT 2 ] DSP EFFECT 3
]DSP EFFECT 4 ] DSP EFFECT 5 ] (back to the beginning)
As the number increases, the selected mode will be more effective. (Normally set the level to “DSP EFFECT 3”.)
NOTE
•You cannot adjust the center speaker output level for the DAP modes and the effect level for All Channel Stereo.
•You can output the test tone in any surround mode, or even when surround mode is not activated.
•Speaker output levels whose source signal indicator is lit can be adjusted without pressing TEST.
•When selecting DVD as the source, you can also adjust the speaker output levels using the choice menu. (A pg. 50)
32